Results 21 to 30 of about 270 (196)
Artificial Neural Network Model for Prediction of Bearing Capacity of Driven Pile
Jurnal Teknik Sipil, 2015 This paper presents the development of ANN model for prediction of axial capacity of a driven pile based on Pile Driving Analyzer (PDA) test data. As many as 300 sets of high quality test data from dynamic load test performed at several construction ...
Harnedi Maizir +2 more
doaj +3 more sources
Estimation of Impact Hardness of Rocks by Means of Drop Hammer Test.
Shigen-to-Sozai, 1992 The impact hardness of rock is normally determined by using a ‘Protodyakonov’ type drop hammer. However, this test cannot be applied to a wide range of rocks. Therefore, standardized impact hardness test using the ‘Protodyakonov’ type drop hammer was carried out and the correlati ons of the resulting values of impact hardness with the mechanical ...
SHIMADA, Hideki +2 more
openaire +2 more sources
Strengthening of RC Beams with CFC Panels for Improving Impact Resistance
Applied Sciences, 2023 In this study, continuous fiber composite (CFC) panels were used as a strengthening material to improve the impact resistance of reinforced concrete (RC).
Souphavanh Senesavath +3 more
doaj +1 more source
AIP Advances, 2021 Rock burst support of deep rock mass has always been a difficult problem in geotechnical engineering. Aiming at the problem of rock burst in deep rock mass, a new type of pressure yielding and energy-absorbing bolt system is designed in this paper.
Yi Zhang +5 more
doaj +1 more source
Comparative Shear Tests of Bolt Rods Under Static and Dynamic Loading
Studia Geotechnica et Mechanica, 2020 This article presents the methodology and results of single shear tests of bolt rods under dynamic impact loading generated by means of a drop hammer. Comparative analysis was also performed for bolt rod load capacity, stress and shear work under static ...
Pytlik Andrzej
doaj +1 more source
Shock and Vibration, 2021 To predict the damage to and response of aircraft structures during wheel-up crash landing, numerical simulations were performed using a constitutive and damage model for ductile metallic materials developed in the ABAQUS/Explicit environment.
Pengfei Zhang +3 more
doaj +1 more source
Study on dynamic response characteristics of jointed coal mass under impact load
Meikuang AnquanBased on the similarity theorem, the material ratio of similar coal body is determined, and the single-layer thin-plate coal body is prepared by pouring.
Jianfeng LIU
doaj +1 more source
An experimental study of impact performance of RC piers with different reinforcement ratios
Građevinar, 2019 The most advanced domestic super-high drop hammer impact test system was used in this study to simulate ship-piers collisions. The main focus of this study was to examine the impact forces, displacements, and strain time histories of five reinforced ...
Xiwu Zhou +4 more
doaj +1 more source
Impact Resistance Test and Numerical Simulation Study of Scrap Steel Fiber Rubber Concrete
BuildingsThe scrap steel fibers (SSF) produced by mechanical processing are processed and added to rubber concrete (RC) to make scrap steel fiber rubber concrete (SSFRC), so as to enhance the strength of the rubber concrete.
Mingshuai Li +4 more
doaj +1 more source
Prediction Model of Drilling Performance for Percussive Rock Drilling Tool
Advances in Civil Engineering, 2020 This study suggests a method for quantitatively estimating the drilling performance of the down-the-hole (DTH) hammer during percussive drilling of rock surfaces. A pneumatic dynamic model of the DTH hammer was developed that considers the mass flow rate
Dae-Ji Kim +6 more
doaj +1 more source