Results 41 to 50 of about 70,881 (202)

Direct Cooling of Microsystems Using a Two-Phase Microfluidic Droplet

open access: yesComputation
Droplet-based microfluidics offers a promising approach for enhancing heat transfer in microchannels, which is critical for the thermal management of microsystems.
Wenpei Lu   +3 more
doaj   +1 more source

Evaporation of nanofluid droplet on heated surface

open access: yesAdvances in Mechanical Engineering, 2015
In this study, an experiment on the evaporation of nanofluid sessile droplet on a heated surface was conducted. A nanofluid of 0.5% volumetric concentration mixed with 80-nm-sized CuO powder and pure water were used for experiment. Droplet was applied to
Yeung Chan Kim
doaj   +1 more source

Droplet Transfer Induced Keyhole Fluctuation and Its Influence Regulation on Porosity Rate during Hybrid Laser Arc Welding of Aluminum Alloys

open access: yesMetals, 2021
Hybrid laser arc welding (HLAW) features advantages such as higher welding speed and gap tolerance as well as smaller welding deformation and heat-affected zone than arc welding.
Leilei Wang   +3 more
doaj   +1 more source

Three dimensional features of convective heat transfer in droplet-based microchannel heat sinks [PDF]

open access: yes, 2015
Convective heat transfer in droplet-based microchannel heat sinks can be enhanced by the recirculating vortices due to the presence of interfaces. In rectangular microchannels, the three dimensional structures of the vortices and the ‘gutters’ (i.e., the
Yang, C   +8 more
core   +1 more source

Online Detection of Keyhole Status in a Laser-MIG Hybrid Welding Process

open access: yesMetals, 2022
During laser-metal inert gas (MIG) hybrid welding, a large amount of welding status information is generated in droplet transfer, keyhole and molten pool.
Xi’an Fan   +3 more
doaj   +1 more source

Evaporative Heat Transfer from an Electrowetted Liquid Ribbon on a Heated Substrate

open access: yes, 2013
Evaporation of narrow water ribbons (of 5 and 7 lL volume) formed on a heated surface is investigated. Chemical and structural patterning of a silicon substrate is employed to fabricate a hydrophilic stripe that bisects hydrophobic pillar arrays of ...
Garimella, Suresh V.   +3 more
core   +1 more source

Droplet size and surface hydrophobicity enhance bacterial plasmid transfer rates in microscopic surface wetness

open access: yesISME Communications, 2022
Conjugal plasmids constitute a major engine for horizontal gene transfer in bacteria, and are key drivers of the spread of antibiotic resistance, virulence, and metabolic functions.
Tomer Orevi   +2 more
doaj   +1 more source

Fundamental studies of combustion of droplet and vapour mixtures [PDF]

open access: yes, 2010
There are few experimental data of a fundamental nature that clearly demonstrate the similarities and differences in burning rates between single phase and two phase combustion, either in laminar or turbulent conditions. Such data are essential towards a
Saat, Aminuddin
core  

The effect of droplet size and liquid water content on ice accretion and aerodynamic coefficients of tower legs [PDF]

open access: yes, 2013
An experimental study was conducted to examine the effects of varying the cloud characteristics on ice accretion on tower legs and on the aerodynamic coefficients around the ice-covered legs.
Van Dyke, P.   +3 more
core   +1 more source

Analysis of plasma morphology and droplet transfer in magnetically controlled laser-MIG hybrid welding of 2507 super duplex stainless steel

open access: yesHanjie xuebao
To solve the problems of low efficiency and imbalanced duplex phase proportion of weld seam caused by complex thermal cycles in traditional arc welding of duplex stainless steel, a novel high-efficiency magnetically controlled laser-MIG hybrid welding ...
Minghao CHEN   +6 more
doaj   +1 more source

Home - About - Disclaimer - Privacy