Results 151 to 160 of about 32,227 (313)

Design of a test rig for the characterization of friction and wear in hot-metal gas-forming of AA 5083 aluminium sheets

International Journal of Lightweight Materials and Manufacture
Advanced aluminium sheet-forming processes such as the hot-metal gas-forming represent a challenging solution for producing small lots in the high-end car bodies industry, and the adoption of single cavity moulds made from low-cost, easily machinable ...
Federico Simone Gobber, Alexandru Tancau, Leonardo Daniele Scintilla, Marco Fontana, Marco Actis Grande   +4 more
doaj   +1 more source

Dry Sliding Tribological Behaviors of Electrodeposited Ni-GO/SiC Composite Coating on the 2218 Aluminum Alloy. [PDF]

Materials (Basel), 2022
Yan Y, Lu L, Huo Y.
europepmc   +1 more source

Low‐Fraction Irregular Inclusions Trigger Large Compression Stiffening in Biopolymer Hydrogels

Advanced Functional Materials, EarlyView.
Irregular inclusions at low filler fractions trigger large compression stiffening in biopolymer hydrogels. By promoting contact‐network formation under compression, these inclusions induce non‐affine rearrangements, stretch surrounding fibers, and provide parallel load‐bearing pathways.
Xuechen Shi, Jordan L. Shivers, Fred C. MacKintosh, Paul A. Janmey   +3 more
wiley   +1 more source

Leverage of Environmental Pollutant Crump Rubber on the Dry Sliding Wear Response of Epoxy Composites. [PDF]

Polymers (Basel), 2021
Shahapurkar K, Chenrayan V, Soudagar MEM, Badruddin IA, Shahapurkar P, Elfasakhany A, Mujtaba MA, Siddiqui MIH, Ali MA, Mahlia TMI.   +9 more
europepmc   +1 more source

Wear modelling of diamond-like carbon coatings against steel in deionised water [PDF]

, 2014
Diamond-Like Carbon (DLC) coatings are thin protective surface coatings used to reduce friction and minimise wear in a wide range of applications. The focus of this work is the use of DLC coatings within Rolls-Royce’s pressurised water reactors. A strong
Sutton, Daniel Christopher
core  

Spatially‐Resolved Coherence of Organic Molecular Spins at Room‐Temperature

Advanced Functional Materials, EarlyView.
Molecular spin qubits are emerging as a promising quantum sensing technology. This paper studies the variation in coherence and sensitivity in both crystalline and thin‐film samples by combining microscopy and room temperature optically detected coherent control.
Adrian Mena, Nicholas P. Sloane, Max R. Bonengel, Cameron M. Gould, Scott A. Sulway, Dane R. McCamey   +5 more
wiley   +1 more source

Investigation of Dry Sliding Friction, Wear and Mechanical Behavior of the Ti-6Al-7Nb Alloy after Thermal Oxidation. [PDF]

Materials (Basel), 2022
Aniołek K, Barylski A, Kowalewski P, Kaptacz S.   +3 more
europepmc   +1 more source

Chemical and physical aspects of wear processes in polymers [PDF]

, 1972
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.A series of homogeneous halogen containing polymers have been studied whilst sliding against mild steel and oxides present on mild steel.
Richardson, MOW
core  

Glucose Deprivation‐Driven Concurrent Induction of Apoptosis/Disulfidptosis/Ferroptosis by Tumor Targeting Nanoassemblies in Triple‐Negative Breast Cancer Therapy

Advanced Functional Materials, EarlyView.
Innovative hybrid nanoassemblies installed with ferrocene, D‐α‐tocopherol succinate, and phloretin exploit the metabolic vulnerability of triple‐negative breast cancer under glucose starvation. By blocking glucose uptake, this single nanoplatform simultaneously orchestrates apoptosis, disulfidptosis, and ferroptosis to achieve synergistic and ...
Song Yi Lee, ChaeRim Hwang, Seong Eun Kim, Mrinmoy Karmakar, Seo Jin Jung, Hyeonseok Jang, Hae‐In Kim, Heejung Yang, Junmin Lee, Dae‐Duk Kim, Hyun‐Jong Cho   +10 more
wiley   +1 more source

Dry Sliding Behavior of an Aluminum Alloy after Innovative Hard Anodizing Treatments. [PDF]

Materials (Basel), 2021
Soffritti C, Fortini A, Nastruzzi A, Sola R, Merlin M, Garagnani GL.   +5 more
europepmc   +1 more source