Results 261 to 270 of about 4,478,688 (304)
Some of the next articles are maybe not open access.
Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films, 1991
Low-temperature electron-cyclotron-resonance microwave plasma etching and reactive ion etching are described for ULSI device fabrication. Highly selective anisotropic etching at a high rate, which implies dry etching without tradeoffs, is performed without changing the discharge parameters.
Shinichi Tachi +3 more
openaire +1 more source
Low-temperature electron-cyclotron-resonance microwave plasma etching and reactive ion etching are described for ULSI device fabrication. Highly selective anisotropic etching at a high rate, which implies dry etching without tradeoffs, is performed without changing the discharge parameters.
Shinichi Tachi +3 more
openaire +1 more source
OPTIMIZING TEMPERATURE IN MUSHROOM DRYING
Journal of Food Processing and Preservation, 2008ABSTRACT Mushroom slices after blanching were dried using heated air at 45, 55, 65, 75, 85 and 95C to about 5% moisture content. Organoleptic evaluation of mushroom soup and rehydrated slices, browning index indicative of color and the rehydration quality were used to establish safe temperature for drying mushroom.
C.K. LIDHOO, Y.C. AGRAWAL
openaire +1 more source
Preparation of dry reconstituted liposomal powder by freeze-drying at room temperature
Journal of Liposome Research, 2010The aim of this study was to develop a novel, one-step method of liposome preparation by freeze-drying at room temperature as well as to investigate the physicochemical properties of dry reconstituted liposomal powder that was prepared. The method was based on utilizing sublimation of a volatile solid inert carrier, that is, chlorobutanol hemihydrate ...
Ruthairat, Benjakul +2 more
openaire +2 more sources
Energy Efficiency of Multi-Stage Adsorption Drying for Low-Temperature Drying
Drying Technology, 2009This work discusses the evaluation of multi-stage adsorption dryers with air dehumidification by zeolite and alumina pillared clay. In a multi-stage dryer, product is dried in succeeding stages while air leaving a stage is fed to the next stage after dehumidification by an adsorbent.
Djaeni, M. +4 more
openaire +3 more sources
Drying Technology, 2001
This paper summarizes the results of long-term studies on high-temperature spray drying performed at the Institute of Engineering Thermophysics in Kiev. Two-stage processing involving evaporation followed by drying is proposed to dewater very dilute and temperature-sensitive materials.
openaire +1 more source
This paper summarizes the results of long-term studies on high-temperature spray drying performed at the Institute of Engineering Thermophysics in Kiev. Two-stage processing involving evaporation followed by drying is proposed to dewater very dilute and temperature-sensitive materials.
openaire +1 more source
CRITlCAL TEMPERATURE FOR BARLEY DRYING
Drying Technology, 1993ABSTRACT Eighteen drying experiments on malting barley variety Jarek with initial moisture content ranging from 8to 29 % (w.b.) and exposure time from 0.5 to 5.0 hours were carried out. Drying chamber was not equipped with a fan. so the barley drying was slow.
openaire +1 more source
LOW TEMPERATURE DRY HEAT STERILIZATION
Medical Journal of Australia, 1969K H, Clapp, A W, Derrington
openaire +2 more sources