Results 11 to 20 of about 1,866 (267)
Strength and work-hardening in steels are discussed from the viewpoint of heterogeneous deformation. In-situ neutron diffraction studies made it clear that misfit strains between grains accompanied grain-scaled internal stresses (intergranular stress ...
Satoshi Morooka +6 more
doaj +1 more source
Spinodal decomposition and radiation damage of a FeCuMnNi high-entropy alloy
The precipitation of Cu-rich phases during the irradiation process will reduce radiation resistance in Fe-Cu-Mn-Ni reactor pressure vessel steels. Therefore, high-entropy alloys with excellent radiation resistance are expected to replace reactor pressure
Qingwei Guo +5 more
doaj +1 more source
Study of Diffusible Behavior of Hydrogen in First Generation Advanced High Strength Steels
This study deals with microstructural influence on the H permeation behavior of Dual-Phase (DP) and Complex Phase (CP) steels using electrochemical permeation studies.
Dwaipayan Mallick +3 more
doaj +1 more source
Electrochemical Noise Measurements of Advanced High-Strength Steels in Different Solutions
Advanced high-strength steels (AHSS), are commonly used in the manufacture of car bodies, as well as in front and rear rails, and safety posts. These components can be exposed to corrosive environments for instance, in countries where de-icing salts are ...
Marvin Montoya-Rangel +8 more
doaj +1 more source
The cyclic plastic deformation of an archetypal microstructure dual phase steels has been examined via micromechanics modelling based on representative volume elements technique.
Amit Kumar Rana +2 more
doaj +1 more source
The effects of quasi-static strain rates on the tensile properties of two commercial ferrite-martensite dual-phase DP 600 and DP 800 steels were investigated using strip-shaped samples.
W. Khraisat
doaj +1 more source
In the present study, the effects of various heat treatments on the microstructure and mechanical properties of dual phase ODS steels were investigated to enhance the high strength at elevated temperature.
SANGHOON NOH +6 more
doaj +1 more source
A proposed alternative method for processing dual phase (DP) steels is the utilization of a cold-rolled duplex ferrite-martensite structure, followed by intercritical annealing.
Y.G. Deng, Y.P. Yang
doaj +1 more source
Ferrite/bainite (F/B) dual-phase pipeline steels with excellent balance of strength, ductility, and toughness have been broadly applied in oil and gas pipeline transmission.
Zhong-tao Zhao +5 more
doaj +1 more source
Mechanical Behaviour of Dual Phase Steels under Different Strain Rates [PDF]
The objective of this research was to analyse the stress and strain behaviours of the triaxiality specimens (specimens of different shaping) of dual-phase steels, respectively DP600 and DP800, whose microstructures mainly comprise ferrite and martensite ...
Labinot Topilla, Serkan Toros
doaj +1 more source

