Results 101 to 110 of about 45,251 (307)
Advances in Materials Science and Engineering, 2015 While NaNO2 addition can greatly inhibit the corrosion of carbon steel and ductile cast iron, in order to improve the similar corrosion resistance, ca. 100 times more NaNO2 addition is needed for ductile cast iron compared to carbon steel.
K. T. Kim +5 more
doaj +1 more source
Analysis of Factors Influencing Microstructure and Mechanical Properties of Austempered Ductile Iron
Communications, 2009 The paper deals with some factors influencing microstructure and mechanical properties of austempered ductile iron (ADI). Final structure and properties of ADI are obtained by exactly controlled process of heat treatment of nodular cast iron.
Alan Vasko
doaj +1 more source
Microelectrode evaluation of in situ oxidant reactivity and pH variability at new ductile iron and copper coupon surfaces. [PDF]
Water Res, 2023 Lee WH +4 more
europepmc +1 more source
Hollow rolling element bearings [PDF]
, 1973 A low mass rolling element with a lightweight core and hollow center was developed for use in bearings. The core is plated so as to provide a hard surface and increase the life and reliability of the high speed ball ...
Parker, R. J.
core +1 more source
Advanced Science, EarlyView.Merging 4D printing with magneto‐responsive shape memory polymers opens new avenues for intelligent, reconfigurable systems. This review navigates cutting‐edge fabrication techniques, magnetic fillers, and smart polymer matrices, unveiling their potential in soft robotics, biomedical devices, and wearable tech.
Kiandokht Mirasadi +7 more
wiley +1 more source
Metalurgija, 2016 Mechanical properties and corrosion resistance of metals are closely related to the microstructure characteristics of the material. The paper compares the results of these two sets of properties after investigating samples of base ductile iron and heat ...
M. Janjić +4 more
doaj
Pin-On-Disc Characterization of Brass/Ferritic and Pearlitic Ductile Iron Rubbing Pair
High Temperature Materials and Processes, 2011 Wear behaviour of special brass produced through two different methods (centrifugal and sand casting) was investigated. The wear tests were carried out at sliding velocities of 0.2 ms–1, 0.3 ms–1, 0.4 ms–1 and 0.5 ms–1 and under 10 N, 20 N, and 40 N ...
Çetin Melik
doaj +1 more source
Comparison of the Mechanical Properties of Ductile Cast Iron Intended for Gas Gate Valves with Nickel Cast Iron with an Austenitic Matrix [PDF]
Archives of Foundry EngineeringThe study presents a comparison of the results of structural tests, impact strength and strength properties of cast iron EN-GJS-400-15, which is produced in industrial conditions and the ductile cast iron, with addition of nickel, in austenitic matrix ...
A. Rączka, A. Szczęsny, D. Kopyciński
doaj +1 more source
Microstructure and Dry/Wet Tribological Behaviors of 1% Cu-Alloyed Austempered Ductile Iron. [PDF]
Materials (Basel), 2023 Hsu CH, Lin CY, You WS.
europepmc +1 more source
Bio‐Based Wax Interfaces for Droplet Energy Harvesting at Fluoropolymer‐Like Output Levels
Advanced Science, EarlyView.Replacing unsustainable fluorinated polymers in droplet‐based energy harvesters is usually limited by low power outputs, but carefully selected bio‐based polymers are capable of creating fluoropolymer‐like voltage outputs. Abstract Droplet impact and rebound on solid surfaces has emerged as a promising method for energy harvesting, typically ...
Behnam Kamare +4 more
wiley +1 more source