Results 61 to 70 of about 877,696 (103)
Characterization of Dual Matrix Structured Ductile Iron [PDF]
, 2016 The dual matrix structured ductile iron consists of a soft phase(ferrite)and a hard phase(martensite).The combination of soft and hard phase increases the toughness and strength significantly and meets the requirement of automotive industries for their ...
Patra, Sanjeev Kumar
core
Investigation of thin wall ductile iron parameter [PDF]
, 2009 This thesis deals with thin wall ductile iron parameter.There are two main objectives of this research,firstly, to investigate the processing parameter of thin wall ductile iron by using Sandwich method and to investigate the process design parameter for
Mohd Khairi, Mohd Noor
core +2 more sources
The pressure treatment effect on the high‑strength austempered ductile iron structure
Литьë и металлургияThis paper presents the results of a study on the effect of pressure treatment (direct hot extrusion) on the structure of graphite inclusions and the metallic matrix of high‑strength austempered ductile iron. Comparative analysis of the cooling processes
P. E. Lushchik +3 more
doaj +1 more source
Metalurgija, 2016 Mechanical properties and corrosion resistance of metals are closely related to the microstructure characteristics of the material. The paper compares the results of these two sets of properties after investigating samples of base ductile iron and heat ...
M. Janjić +4 more
doaj
Advances in Materials Science and Engineering, 2015 While NaNO2 addition can greatly inhibit the corrosion of carbon steel and ductile cast iron, in order to improve the similar corrosion resistance, ca. 100 times more NaNO2 addition is needed for ductile cast iron compared to carbon steel.
K. T. Kim +5 more
doaj +1 more source
Evaluation of producing technique factors affecting the matrix microstructure of as-cast ductile iron castings [PDF]
Metalurgija, 2011 The objective of this paper was to investigate some important parameters related to ductile iron matrix microstructure. Ductile iron round bars of various diameters in order to achieve various cooling rates were obtained in different conditions.
S. Bockus, G. Zaldarys
doaj
Pin-On-Disc Characterization of Brass/Ferritic and Pearlitic Ductile Iron Rubbing Pair
High Temperature Materials and Processes, 2011 Wear behaviour of special brass produced through two different methods (centrifugal and sand casting) was investigated. The wear tests were carried out at sliding velocities of 0.2 ms–1, 0.3 ms–1, 0.4 ms–1 and 0.5 ms–1 and under 10 N, 20 N, and 40 N ...
Çetin Melik
doaj +1 more source
, 2011 [[abstract]]This study elucidates the effect of residual magnesium content and heating temperature on the thermal cyclic failure behaviour of ductile irons by applying repeated heating and cooling cycles.
Cheng, C. P.;Lui, T. S.;Chen, L. H.
core
Shielded Capacitive Power Transmission (S-CPT) System Using Cast Iron
EnergiesIn this study, we investigate a shielded capacitive power transfer (S-CPT) system that employs cast iron road covers as transmission electrodes for both dynamic and static charging of electric vehicles.
Eiichi Tateishi +9 more
doaj +1 more source
Thin wall ductile iron castings: technological aspects [PDF]
, 2013 The paper discusses the reasons for the current trend of substituting ductile iron castings by aluminum alloys castings. However, it has been shown that ductile iron is superior to aluminum alloys in many applications.
Kapturkiewicz, W., Górny, M., Fraś, E.
core