Results 11 to 20 of about 11,921 (257)
Dynamic Recrystallization Behaviours in Metals and Alloys. [PDF]
Materials (Basel), 2023 The existence of dynamic recrystallization (DRX), i [...]
Montheillet F.
europepmc +4 more sources
Modeling the Dynamic Recrystallization and Flow Curves Using the Kinetics of Static Recrystallization. [PDF]
Materials (Basel), 2019 The results of modeling the dynamic recrystallization of steels during hot deformation on the basis of information on their static recrystallization kinetics are presented. The results of predicting the amount of deformation accumulated in the metal under the conditions of dynamic recrystallization development were used for calculating the metal flow ...
Shkatov V, Mazur I.
europepmc +4 more sources
Deformation behavior and softening mechanism in ferrite steel during warm deformation
Journal of Materials Research and Technology, 2022 Ferrite rolling is generally used to produce deep-drawn steel sheets, which can replace cold rolling to achieve short-flow production. Realizing low-cost production of deep-drawn steel.
Leilei Li +3 more
doaj +1 more source
Research progress on dynamic recrystallization behavior of Al-Li alloy
Journal of Aeronautical Materials, 2022 Al-Li alloy has been widely used in aerospace field attribute to the advantages of lower density, higher strength, damage tolerance and corrosion resistance. Dynamic recrystallization phenomena exist in Al-Li alloy during hot deformation.
GUO Youjie +7 more
doaj +1 more source
Dynamic recrystallization behavior of 6082 aluminum alloy during hot deformation
Advances in Mechanical Engineering, 2021 The dynamic recrystallization behaviors of 6082 aluminum alloy in the temperature range of 623–773 K and strain rate range of 0.01–5 s −1 were studied by electron back scattered diffraction (EBSD) and transmission electron microscopy (TEM).
Hai-bo Lin
doaj +1 more source
Recrystallization mechanisms and texture evolution of AZ31 alloy by gradient caliber rolling
Journal of Materials Research and Technology, 2023 A single-pass gradient caliber rolling of a conical-shaped AZ31 Mg alloy was performed at 723 K to obtain a transitional microstructure with strain ranging from 0 to 30%.
Hui Yu +8 more
doaj +1 more source
Cailiao gongcheng, 2023 The comparative experiments of 2A12/AZ31B dissimilar materials friction stir welding (FSW) and ultrasonic vibration assisted FSW (UVaFSW) were carried out.
JING Rui +3 more
doaj +1 more source
Journal of Materials Research and Technology, 2022 The S280 ultra-high strength stainless steel was subjected to isothermal constant strain rate compression experiments under the conditions of deformation temperature 1000–1150 °C and strain rate 0.001–10 s−1 by Thermecmaster-Z thermal simulation testing ...
Kaiming Zhang +5 more
doaj +1 more source
Metals, 2021 The two-pass thermal compression behavior of near-β Ti-55511 alloy was investigated. The first-pass restoration mechanisms changed from dynamic recrystallization (DRX) to dynamic recovery (DRV) as the first-pass deformation temperature increased from 700
Hande Wang +4 more
doaj +1 more source
The Critical Conditions and Kinetics Required for Dynamic Recrystallization in a High-Carbon Tool Steel [PDF]
Archives of Metallurgy and Materials, 2020 A hot compression test was conducted on a Gleeble-3500 thermo-simulation machine to study the critical conditions and kinetics of dynamic recrystallization in a high-carbon tool steel.
Yong-Ji Zhang +2 more
doaj +1 more source