Results 11 to 20 of about 1,277,194 (266)
Performance of a centrifugal pump running in inverse mode [PDF]
, 2004 This paper presents the functional characterization of a centrifugal pump used as a turbine. It shows the characteristics of the machine involved at several rotational speeds, comparing the respective flows and heads.
Parrondo, J +4 more
core +4 more sources
An analysis of reliability of electric submersible centrifugal pumps
Journal of Physics: Conference Series, 2022 Abstract The average operating time before structural and technological failures of the submersible part of a typical ESP is 64.5–81.9% of the average operating time of new ESPs. Given that the set of typical ESPs includes a significant share of repaired and mixed (equipped with new and refurbished units) installations, this fact can be ...
M Ya Khabibullin, R I Suleimanov
openaire +1 more source
Fluids, 2023 Raising the working speed of hydraulic pumps to maximize the efficient matching range of electric motors is one of the possible ways to achieve energy efficiency in electric machinery.
Fei Sun +3 more
doaj +1 more source
Expert system to select a proper chemigation-injection system according to field condition [PDF]
Archives of Agriculture Sciences Journal, 2021 The aim of this research is to help in selecting an appropriate chemical injector in certain situations. Systems under investigation included: (1) Bypass pressure differential tank, (2) Piston injection pump, (3) With suction pipe of irrigation pump, (4)
A. El Lithy, A. Elglaly
doaj +1 more source
The investigation of motor current signals from a centrifugal pump for fault diagnosis [PDF]
, 2014 In this paper, motor current signals from electrical control systems, rather than installing additional measurement systems, are characterised for the fault diagnosis of centrifugal pumps.
Chen, Zhi +5 more
core +3 more sources
Омский научный вестник, 2023 The article considers the construction of a simulation model of an electrical complex including an asynchronous electric motor with frequency regulation, driving a centrifugal pump.
O. A. Lysenko
doaj +1 more source
A simulation model of electric actuator unit of electric centrifugal pump with a submersible individual compensation installation [PDF]
E3S Web of Conferences, 2019 The substitution scheme and the system of differential equations for electrotechnical complex of producing well are given. The mathematical and simulation models of electric drive of electric centrifugal pump installation with submersible individual ...
Tabachnikova T.V., Erashova Y.N.
doaj +1 more source
Dynamic Modes of Synchronous Electric Drive with Centrifugal Hydraulic Load of Pump Station
Energy Engineering and Control Systems, 2021 The contemporary state of the modelling of the pump station’s electric drive in a complex with its centrifugal hydraulic load has been analysed. It was found that most studies focus either on the modelling and development of automatic control systems for
Vladyslav Lysiak, Mykhailo Oliinyk
doaj +1 more source
Известия Томского политехнического университета: Инжиниринг георесурсов, 2019 The relevance of the research is caused by the need to solve the problem of removal of gas accumulating in the annular space of oil producing wells at the inlet of a submersible centrifugal pump.
Diana A. Saracheva +2 more
doaj +1 more source
Operation effectiveness of wells by enhancing the electric- centrifugal pump [PDF]
IOP Conference Series: Earth and Environmental Science, 2016 We present the method to improve the operation effectiveness of wells by enhancing the electric-centrifugal pump. Some of the best ways to extend the electric-centrifugal pumps operating lifetime is using today's techniques as well as additional protective equipment as a part of the electric-centrifugal pump.
Zyatikov, Pavel Nikolaevich +2 more
openaire +2 more sources