Results 101 to 110 of about 101,598 (314)
Modeling of Hydraulic Load of Electric Drive in Electrical Complex of Pumping Station [PDF]
, 2018 The paper analyses the contemporary state of the electric drive hydraulic load modelling in the pumping stations’ electrotechnical complex applications. It was found that in the vast majority of cases, mathematical models do not allow taking into account
Yurii Shelekh +2 more
core +1 more source
Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition
Advanced Engineering Materials, EarlyView.A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Research of the Test Bench and Method of Integrated Electric Drive Axle for Light Commercial Vehicle
Jixie chuandong, 2020 Aiming at the test requirements of integrated electric drive axle for light commercial vehicle， the test bench of integrated electric drive axle for light commercial vehicle is designed.
Rui Zhan +3 more
doaj
Model based development of torque control drive for induction motors for micro electric vehicles [PDF]
, 2022 Electric vehicles are attaining significant attention recently and the current legislation is forcing the automotive industry to electrify the productions.
Al-Alawi, M. K., Nikzadfar, K.
core
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Multiphase induction motor drives - a technology status review [PDF]
, 2007 The area of multiphase variable-speed motor drives in general and multiphase induction motor drives in particular has experienced a substantial growth since the beginning of this century.
Williamson, S +12 more
core +1 more source
Advanced Engineering Materials, EarlyView.A unified research data management framework for heterogeneous materials data is presented. The system integrates multimodal datasets using ontologies and knowledge graphs, enabling interoperability and FAIR (findable, accessible, interoperable, reusable) data principles. By linking data across scales and workflows, it supports reproducible, Artifitial
Doaa Mohamed +6 more
wiley +1 more source
On-Site Calibration of an Electric Drive: A Case Study Using a Multiphase System. [PDF]
Sensors (Basel), 2023 Soto-Marchena D +4 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.A two‐dimensional multiscale finite element analysis framework was established for the first‐generation MoSiBTiC alloy, and the mechanical and fracture‐related parameters of the constituent phases were calibrated through experiments and simulations. The framework provides a basis for analyzing crack propagation behavior in its complex microstructure ...
Junfeng Du +4 more
wiley +1 more source