Results 61 to 70 of about 112,571 (192)
Frequency-temperature response of a new multiferroic [PDF]
Processing and Application of Ceramics, 2014 The frequency dependence of the electrical properties of a new complex multiferroic Bi4Pb2Ti3FeNbO18 at different temperatures was investigated by impedance spectroscopy technique. The impedance spectroscopic data were collected at different frequencies (
Nawnit Kumar +2 more
doaj +1 more source
Ceramics, 2021 In this work, Zn2+-doped TiO2:WO3 nanostructured films, with different doping levels, were produced by electrospinning followed by sintering, and tested as potential materials for relative humidity (RH) detection.
Georgenes M. G. Silva +4 more
doaj +1 more source
Real-Time Monitoring of Stem Cells by Diamond-Based Impedance Sensors
Proceedings, 2017 Cell-based impedance spectroscopy is a promising label-free method for electrical monitoring of cell activity. Here we present a diamond-based impedance sensor with built-in gold interdigitated electrodes (IDEs) as a promising platform for simultaneous ...
Václav Procházka +6 more
doaj +1 more source
On-Chip Detection of Beads with a New Electrical Impedance Sensor [PDF]
, 2010 Electrical impedance measurements in microfluidic chips are used for single cell analysis. Parallel electrodes are more suited than planar ones since the electrical field distribution is more homogenous.
Berg, Albert van den +3 more
core +3 more sources
Microfluidic Electrical Impedance Spectroscopy
, 2020 The goal of this study is to design and manufacture a microfluidic device capable of measuring changes in impedance valuesof microfluidic cell cultures. Tocharacterize this, an interdigitated array of electrodes was patterned over glass, where it was then bonded to a series of fluidic networks created in PDMS via soft lithography.
openaire +2 more sources
FoodsThe electrical impedance of dilute aqueous solutions containing extracts from five brands of canned tuna is analyzed using impedance spectroscopy in order to analyze their salt content and detect the potential presence of other salts beyond the well ...
Inés Zabala +5 more
doaj +1 more source
Ac conductivity and dielectric properties of CuFe1−xCrxO2 : Mg delafossite [PDF]
, 2011 The electrical and dielectric properties of CuFe(1−x)Cr(x)O(2) (0 ≤ x ≤ 1) powders, doped with 3% of Mg and prepared by solid-state reaction, were studied by broadband dielectric spectroscopy in the temperature range from −100 to 150 °C.
A Barnabé +7 more
core +3 more sources
Preparation and characterization of Bi26–2xMn2xMo10O69-d and Bi26.4Mn0.6Mo10–2yMe2yO69-d(Me = V, Fe) solid solutions [PDF]
, 2017 Received: 06.06.2017; accepted: 23.06.2017; published: 14.07.2017.Single phase samples of bismuth molybdate, Bi26Mo10O69, doped with Mn on the bismuth sublattice and V, Fe on the molybdenum sublattice were found to crystallize in the triclinic ...
Buyanova, E. S. +5 more
core +3 more sources
The measurement of very low conductivity and dielectric loss in XLPE cables: A possible method to detect degradation due to thermal aging [PDF]
, 2011 The dielectric response of crosslinked polyethylene (XLPE) insulated, miniature power cables, extruded with inner and outer semicons, was measured over the frequency range 10-4 to 104 Hz at temperatures from 20 to 100 °C.
Dissado, L. A. +4 more
core +1 more source
Application of Electrical Properties to Differentiate Lard From Tallow and Palm Oil [PDF]
, 2013 This study aimed to differentiate lard from tallow and palm oil based on its electrical properties, namely conductance, impedance and capacitance. These properties were measured at spectra frequencies of 4.20 to 5.00 MHz in room temperature (26-27 oC ...
Djatna, T. (T) +4 more
core