Results 51 to 60 of about 638,729 (307)
The effect of Cu concentration on some of the electrical properties of CdSe films
Iraqi Journal of Physics, 2008 The CdSe pure films and doping with Cu (0.5, 1.5, 2.5, 4.0wt%) of thickness 0.9μm have been prepared by thermal evaporation technique on glass substrate. Annealing for all the prepared films have been achieved at 523K in vacuum to get good properties of
E. M. Al-Fwadi
doaj
Dielectrical and electrical properties of PVA-NaI composites
Iraqi Journal of Physics, 2019 The electrical characteristics of polyvinyl alcohol PVA doped with different concentrations (0, 1, 2, 3 and 4wt%) of sodium iodide NaI powder were studied. The films are prepared using solution casting technique, in order to investigate
Hussein Neama Najeeb
doaj +1 more source
Carbon Nanotubes as an Alternative to Copper Wires in Electrical Machines: A Review
Energies, 2023 The surge in electric vehicles (EVs) and their electrical appliances requires highly efficient, lightweight electrical machines with better performance.
Vigneselvan Sivasubramaniyam +4 more
doaj +1 more source
Electrical properties of Sb and Cr-doped PbZrO3-PbTiO3-PbMg1/3Nb2/3O3 ceramics [PDF]
, 2003 The pyroelectric, dielectric and DC resistive properties of Sb and Cr-doped ceramics with a base composition of Pb(Mg1/3Nb2/3)0.025(Zr0.825Ti0.175)0.975O3 have been studied. Sb doping has been shown to produce a linear reduction in Curie temperature (TC=−
Molter, O. +2 more
core +1 more source
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source
Electrical properties of various single-wall carbon nanotube networks [PDF]
, 2010 This thesis investigates conduction mechanisms of covalently and non covalently functionalised single wall carbon nanotube (SWCNT) networks. Unlike previous strategies where diamines were used, a novel route to covalently bridge SWCNTs by organic ...
Jombert, Alice Stécy +1 more
core
Stochastic Jiles-Atherton model accounting for soft magnetic material properties variability [PDF]
, 2013 Industrial processing (cutting, assembly…) of steel laminations can lead to significant modifications in their magnetic properties. Moreover, the repeatability of these modifications is not usually verified because of the tool wear or, more intrinsically,
RAMAROTAFIKA, Rindra +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source
Electrical properties of graphene-metal contacts
Scientific Reports, 2017 The performance of devices and systems based on two-dimensional material systems depends critically on the quality of the contacts between 2D material and metal.
Teresa Cusati +6 more
doaj +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source