Results 171 to 180 of about 178,159 (346)

Artifact‐Minimizing Ultrathin Transparent Electrodes Fabricated via iCVD for In Vivo Optogenetic Stimulation and Neural Signal Monitoring of Primary Visual Cortex

open access: yesAdvanced Functional Materials, EarlyView.
We present ultrathin flexible transparent electrodes through iCVD‐enabled molecular control of 10 nm gold films on poly(dimethylaminomethylstyrene). In vivo validation demonstrated photoelectric artifact reduction vs. opaque electrodes and preservation of natural neural dynamics.
Tae Jin Mun   +11 more
wiley   +1 more source

Data Sheet 1_Balanced multi-electrolyte solution versus normal saline for fluid therapy in aneurysmal subarachnoid hemorrhage: an influence on fluid and electrolytes balance and outcome.docx

open access: green
Yu-Qing Duan (22687454)   +11 more
openalex   +1 more source

Triblock Polymer Engineering Enables Hydration‐Rich, High‐Performance, Fouling‐Resistant Interfaces

open access: yesAdvanced Functional Materials, EarlyView.
A molecularly engineered triblock polymer (PHZ) rapidly reorganizes into a hydration‐rich interfacial layer on diverse surfaces, strongly suppressing hydrophobic attraction and fouling. The triblock polymer provides robust energy and steric barriers to oily foulants, enabling high‐performance antifouling at ultralow dosage.
Chenyu Qiao   +6 more
wiley   +1 more source

Acid-Base and Electrolyte Balance Responses in the Performance of Female Ultramarathon Runners in a 45 km Mountain Race. [PDF]

open access: yesNutrients
Ribas MR   +7 more
europepmc   +1 more source

Voltage‐Gated Dedoping of n‐Doped Poly(benzodifurandione) as an Interfacial Protective Mechanism in Electrochromic Devices

open access: yesAdvanced Functional Materials, EarlyView.
Electrochromic polymer stability under overpotential is improved by inserting an ultrathin, transparent n‐doped poly(benzodifurandione) interlayer between indium tin oxide and a poly(3,4‐propylenedioxythiophene)‐based electrochromic polymer. The interlayer supports rapid switching at operating bias, then becomes resistive near +0.8 V to suppress excess
Priyanka Rout   +4 more
wiley   +1 more source

Receptor‐Free Identification of Toxic Gases Enabled by Hygroscopic Aqueous Salt Films

open access: yesAdvanced Functional Materials, EarlyView.
Water as a gas sensor coating sounds impossible—until it stops evaporating. Here, hygroscopic salt solutions (LiCl, LiBr, H3PO4) form non‐drying aqueous films on CNT chemiresistors under ambient air. Gases partition into these liquid layers, sometimes transforming into water, and generate salt‐specific resistance fingerprints across a four‐channel ...
Seongwoo Lee   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy