Results 211 to 220 of about 3,135 (259)
Some of the next articles are maybe not open access.
Position estimation for linear electromagnetic actuators
2017 IEEE International Symposium on Sensorless Control for Electrical Drives (SLED), 2017This paper explores the possibilities of position estimation for linear electromagnetic actuators, in comparison to rotating electric motors. The linear actuator under study is a DC type short stroke permanent magnet actuator with an E-core stator. The non-linearity in the inductance model is first measured and identified on a commercially available ...
Ali El Hafni +2 more
openaire +1 more source
Loss analysis of electromagnetic linear actuator
International Journal of Applied Electromagnetics and Mechanics, 2014This paper presents the research on loss analysis of the electromagnetic linear actuator (ELA) with the purpose of performance improvement of ELA applied to the engine electromagnetic driven valve train(EDVT). To define ELA's loss distribution and variation, quantitative analysis has been carried out against ELA's loss composition and variation at ...
Dai, Jianguo, Chang, Siqin
openaire +1 more source
Development of linear actuator for electromagnetic pump
International Journal of Applied Electromagnetics and Mechanics, 2019Recently, the majority of artificial hearts have been non-pulsatile types. However natural hearts are pulsatile, and the long-term bio-compatibility of the non-pulsatile types has not been confirmed. We developed a linear actuator that can expect to be applied to pulsatile artificial heart.
Murakami, Iwanori +3 more
openaire +1 more source
Analysis and Design of Hybrid Electromagnetic Linear Actuator for Linear Pump [PDF]
Jinho Kim
exaly +2 more sources
Application of Linear Electromagnetic Actuators in Vehicular Suspensions
SAE Technical Paper Series, 2023<div class="section abstract"><div class="htmlview paragraph">This study comprehensively describes the application of linear electromagnetic actuators in automotive suspension systems, focusing on the electromagnetic force necessary in suspension systems operating in passive, semi-active, and
Paulo Roberto Eckert +10 more
openaire +1 more source
The PemRam - an electromagnetic linear actuator
IEE Colloquium on Actuator Technology: Current Practice and New Developments, 1996The PemRam was originally designed to replace hydraulics in vehicle simulators. Previously, only high-pressure fluid actuators could provide the bandwidth and precision that was needed for accurate motion simulation but they could not be used in confined spaces close to the general public.
openaire +1 more source
Automobile Suspensions Using Electromagnetic Linear Actuators
IFAC Proceedings Volumes, 2000Abstract The development of rare-earth magnetic materials, power electronics and control has enabled the construction of lighter and smaller permanent magnet actuators. Its reduced friction losses and the natural control flexibility of the electric equipment should allow for improvements in the automobile suspension behaviour.
Isménio Martins +3 more
openaire +1 more source
Linear Electromagnetic Actuators and Their Control: A Review
EPE Journal, 2004Linear electromagnetic actuators develop directly thrust and thus linear motion. In principle rotary motion electromagnetic motors may be turned into their linear counterparts by cutting them axial...
openaire +1 more source
Electromagnetic linear actuators with inductive position sensing
Sensors and Actuators A: Physical, 1996Abstract Magnetically driven linear micro-actuators with 1 mN output force and hundreds of microns of total travel have been realized using LIGA-like processing techniques. These devices are driven at resonance frequencies of around 350 Hz and exhibit quality factors of about 300 in air.
H Guckel +4 more
openaire +1 more source
Robust electromagnetic optimization of linear tubular actuators
IEEE Transactions on Magnetics, 2004The concept of robust optimization of electromagnetic devices using finite-element models is presented. An original "trellis" experimental design is used to achieve the optimization process and a robustness analysis is done using the signal-to-noise ratio. The robustness study deals with modeling and building noises and is applied to the optimal design
L. El Amraoui +4 more
openaire +1 more source

