Results 11 to 20 of about 184,542 (170)
Micromachines, 2023 The enhanced piezoelectric properties of aluminum scandium nitride (Al1−xScxN or AlScN) were discovered in 2009 by Morito Akiyama’s team [...]
Agnė Žukauskaitė
doaj +1 more source
Design and Performance of a Focus-Detection System for Use in Laser Micromachining
Micromachines, 2016 We describe a new approach for locating the focal position in laser micromachining. This approach is based on a feedback system that uses a charge-coupled device (CCD) camera, a beam splitter, and a mirror to focus a laser beam on the surface of a work ...
Binh Xuan Cao +6 more
doaj +1 more source
Two-step hybrid process of movable part inside glass substrate using ultrafast laser
Micro and Nano Systems Letters, 2021 We demonstrate a two-step hybrid process for fabricating movable parts inside glass substrate using the selective laser-induced etching (SLE) process that is consisted of laser-direct writing and wet chemical etching.
Jeongtae Kim +4 more
doaj +1 more source
Glass Substrate Dust Removal Using 233 fs Laser-Generated Shockwave
Micromachines, 2021 Eliminating dust is gaining importance as a critical requirement in the display panel manufacturing process. The pixel resolution of display panels is increasing rapidly, which means that even small dust particles on the order of a few micrometers can ...
Myeongjun Kim +3 more
doaj +1 more source
Composition formulas of solid-solution alloys derived from chemical-short-range orders
Scientific Reports, 2022 Solid solutions are the basis for most industrial alloys. However, the relationships between their characteristic short-range orders and chemical compositions have not been established.
Zhuang Li +5 more
doaj +1 more source
High-Speed Focus Inspection System Using a Position-Sensitive Detector
Sensors, 2017 Precise and rapid focus detection is an essential operation in several manufacturing processes employing high-intensity lasers. However, the detection resolution of existing methods is notably low.
Binh Xuan Cao +5 more
doaj +1 more source
Micromachines, 2022 This study proposes a rapid and inexpensive thermocycler that enables rapid heating of samples using a thin glass chip and a cheap chip resistor to overcome the on-site diagnostic limitations of polymerase chain reaction (PCR). Microchip PCR devices have
Dongsun Yeom +6 more
doaj +1 more source
Sensors, 2017 In modern high-intensity ultrafast laser processing, detecting the focal position of the working laser beam, at which the intensity is the highest and the beam diameter is the lowest, and immediately locating the target sample at that point are ...
Binh Xuan Cao +5 more
doaj +1 more source
Frontiers in Microbiology, 2018 Reports in the literature suggest that bacteria exposed to lethal doses of ionizing radiation, i.e., electron beams, are unable to replicate yet they remain metabolically active.
Anne-Sophie Charlotte Hieke +3 more
doaj +1 more source
Electron Energy Spectrometer for MIR-THz FEL Light Source at Chiang Mai University
Particles, 2023 The linear accelerator system of the PBP-CMU Electron Linac Laboratory has been designed with the aim of generating free-electron lasers (FELs) in the mid-infrared (MIR) and terahertz (THz) regions.
Kittipong Techakaew +2 more
doaj +1 more source