Results 1 to 10 of about 20,319 (267)
Review of Electrothermal Micromirrors
Micromachines, 2022 Electrothermal micromirrors have become an important type of micromirrors due to their large angular scanning range and large linear motion. Typically, electrothermal micromirrors do not have a torsional bar, so they can easily generate linear motion. In
Lixin Xu, Jeong-Bong Lee, Huikai Xie
exaly +6 more sources
Preparation and Electrothermal Properties of Graphene Electrothermal Composite Floor [PDF]
BioResources, 2023 Conventional electrothermal floors suffer from low heating efficiency, uneven temperature distribution across the floor surface, local overheating, and severe heat accumulation.
Jiawei Zhang +9 more
doaj +7 more sources
Journal of Materials Research and Technology, 2023 Electrothermal elements are used in electronic devices, physiotherapy, and health care due to their lightweight and fast temperature response. However, the high cost and susceptibility to oxidation of traditional electrothermal materials limit their ...
Zhaohui Huang, Xiaowen Wu, Bingcheng Luo
exaly +4 more sources
Review of Electrothermal Actuators and Applications
Actuators, 2019 This paper presents a review of electrothermal micro-actuators and applications. Electrothermal micro-actuators have been a significant research interest over the last two decades, and many different designs and applications have been investigated.
Changhai Wang, Alissa Potekhina
exaly +5 more sources
AC Electrothermal Effect in Microfluidics: A Review
Micromachines, 2019 The electrothermal effect has been investigated extensively in microfluidics since the 1990s and has been suggested as a promising technique for fluid manipulations in lab-on-a-chip devices.
Colin Dalton +2 more
exaly +3 more sources
Bridged Conductive Nanofibrous Membrane Overcoming the Porosity‐Conductivity Trade‐Off for Electrothermal Air Purification [PDF]
Advanced ScienceEmerging conductive porous materials hold remarkable promise for Joule‐heating applications like electothermal filtration, smart textiles, and energy management due to their porous and conductive synergy.
Xiaoxue Yao +10 more
doaj +2 more sources
Design and Construction of a 2.45 GHz Microwave Electrothermal Thruster [PDF]
Journal of Nuclear Research and Applications, 2022 A microwave electrothermal thruster (MET thruster) has been constructed, consisting of a microwave plasma chamber 12 cm long and 8 cm in inner diameter and a micronozzle 10 mm long with 1 mm in diameter.
S. Fazelpour +3 more
doaj +1 more source
The influence of plastic deformation and chemical environment on the resistively of al-alloy overhead lines [PDF]
Serbian Journal of Electrical Engineering, 2005 The electrical resistively and intensity of X-ray diffraction reflexes were determined for overhead line wires deformed plastically and immersed at different solutions. Immersing (chemical ageing) was performed by plastic deformation along the wire axis.
Nowak-Woźny D. +4 more
doaj +1 more source
Micromachines, 2021 Micro-electromechanical system (MEMS) micromirrors have been in development for many years, but the ability to steer beams to angles larger than 20° remains a challenging endeavor.
David Torres +4 more
doaj +1 more source
A stretchable superhydrophobic coating with electrothermal ability for anti-icing application
Materials Research Express, 2021 Surface icing in the transmission lines may cause serious accidents. Although the superhydrophobic/electrothermal synergistically anti-icing strategy has been introduced, most coatings tended to lose superhydrophobicity under large deformation.
Yongjing Peng +5 more
doaj +1 more source