Results 101 to 110 of about 1,325 (265)
Advanced Materials Technologies, EarlyView.ABSTRACT Real‐time insight into local chemistry is critical for reliable part quality in additive manufacturing, especially laser powder bed fusion (PBF‑LB/M), where rapid thermal cycles and localized evaporation can undermine part performance. Optical emission spectroscopy (OES) offers non‑intrusive, in situ plume monitoring, but detection geometry ...
Philipp Gabriel +4 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.ABSTRACT Molybdenum disulfide (MoS2) has attracted attention as a promising material due to the growing demand for environmentally friendly, cost‐effective, and efficient water treatment techniques. With its physicochemical characteristics, this stratified bidimensional material allows it to be highly effective in adsorption and catalytic performance ...
Pariksha Bishnoi +4 more
wiley +1 more source
In Situ Two‐Dimensional Residual Stress Characterization of Thin Films
Advanced Materials Technologies, EarlyView.An integrated in situ curvature metrology platform combining speckle‐based curvature optical metrology (SCOM) with multi‐beam optical sensors (MOS) enables spatially resolved two‐dimensional curvature mapping of thick sputtered coatings. The SCOM technique provides excellent agreement with MOS while providing an extended measurable curvature range ...
Wai Jue Tan +6 more
wiley +1 more source
Monotonicity, convexity, and inequalities for the generalized elliptic integrals. [PDF]
J Inequal Appl, 2017 Huang T, Tan S, Zhang X.
europepmc +1 more source
Full‐Stokes Polarimetry Metasurface‐Enabled Single‐Shot Measurement of the Spin Hall Effect of Light
Advanced Optical Materials, EarlyView.This study presents a metasurface‐enabled approach to measure the spin Hall effect of light in a single‐shot. The metasurface splits a reflected light into six polarization‐dependent focal spots, allowing all Stokes parameters to be obtained from single image.
Jeonghoon Choi +6 more
wiley +1 more source
Advanced Optical Materials, EarlyView.Metasurface shows selective solar–thermal energy conversion with high‐activity solar/laser‐driven chemistry. The breakthrough is co‐designing broadband FP‐cavity + plasmonic LSPR/SLR resonances in an ultra‐thin metamaterial so that it not only harvests the most efficient proportion of solar radiation but also suppresses mid and IR emissivity. Moreover,
Samira Mehrabi +4 more
wiley +1 more source
A note on generalized elliptic integral
Journal of Research of the National Bureau of Standards Section B Mathematics and Mathematical Physics, 1964 J. ~ dO n j{k) = 0 (1 - k2 cos 1J)i +112 in th e neighb orhood of k2 = ] is obtained by a meth od based on an Ab eli an theore m .
openaire +2 more sources
Two‐Dimensional Isotropic Spatial Differentiation Through Complete Polarization Control
Advanced Optical Materials, EarlyView.This work enables two‐dimensional isotropic spatial differentiation at planar interfaces over a wide range of incident angles by extending the output polarization from linear to elliptical. The choice of incident angle can be used to balance broader spectral response at low angles and higher edge‐detection efficiency at larger angles.
Doyoon Lee, Minkyung Kim
wiley +1 more source
Two-loop non-planar four-point topology with massive internal loop
Journal of High Energy PhysicsWe study a set of two-loop non-planar master integrals needed for the NNLO QCD corrections to diphoton and dijet production at hadron colliders. The top-sector topology contains an internal massive fermion loop and is known to contain elliptic curves ...
Taushif Ahmed +3 more
doaj +1 more source
Hard‐Magnetic Soft Millirobots in Underactuated Systems
Advanced Robotics Research, EarlyView.This review provides a comprehensive overview of hard‐magnetic soft millirobots in underactuated systems. It examines key advances in structural design, physics‐informed modeling, and control strategies, while highlighting the interplay among these domains.
Qiong Wang +4 more
wiley +1 more source