Results 81 to 90 of about 92,150 (284)
Arthritis Care &Research, EarlyView.Objective Although treat‐to‐target urate‐lowering therapy (ULT) is endorsed as best practice in gout management, limited data exist on its impact on health‐related quality of life (HRQoL). We assessed the impact of treat‐to‐target ULT on HRQoL among participants receiving protocolized gout care, identifying factors associated with HRQoL and HRQoL ...
Austin Barry +16 more
wiley +1 more source
TRANSITION FROM 2D TO 3D WITH GEOGEBRA [PDF]
Romanian Journal of Mathematics and Computer Science, 2014 This article presents the definition of projection plane, its importance for the geometry constructions used in civil engineering and comparative analysis of three opportunities for creating a three dimensional basis, used in drawing such a plane. First
MARIA MIHAILOVA +2 more
doaj
Arthritis Care &Research, EarlyView.Objective This study aims to develop hip morphology‐based radiographic hip osteoarthritis (RHOA) risk prediction models and investigates the added predictive value of hip morphology measurements and the generalizability to different populations. Methods We combined data from nine prospective cohort studies participating in the Worldwide Collaboration ...
Myrthe A. van den Berg +26 more
wiley +1 more source
Mechanical Properties and Microstructures of Ni20Cr Micro-wires with Abnormal Plastic Deformation
High Temperature Materials and Processes, 2017 Ni80Cr20 (Ni20Cr, wt%) micro-wires were fabricated by the cold-drawing method with single die. Abnormal engineering strains were approximately 17.3–46.6 % for each pass.
Zhou Xiuwen +3 more
doaj +1 more source
International Journal of Adaptive Control and Signal Processing, EarlyView.This paper proposes two projector‐based Hopfield neural network (HNN) estimators for online, constrained parameter estimation under time‐varying data, additive disturbances, and slowly drifting physical parameters. The first is a constraint‐aware HNN that enforces linear equalities and inequalities (via slack neurons) and continuously tracks the ...
Miguel Pedro Silva
wiley +1 more source
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez +5 more
wiley +1 more source
International Student-oriented Course Construction and Teaching Practice of Engineering Drawing [PDF]
, 2017 Hong Jia +4 more
openalex +1 more source
Bistable Mechanisms 3D Printing for Mechanically Programmable Vibration Control
Advanced Engineering Materials, EarlyView.This work introduces a 3D‐printed bistable mechanism integrated into tuned mass dampers (TMDs) for mechanically adaptive passive vibration suppression. Through optimized geometry, the bistable design provides adaptable vibration reduction across a broad range of scenarios, achieving effective vibration mitigation without complex controls or external ...
Ali Zolfagharian +4 more
wiley +1 more source
Dynamic Precipitation during High‐Pressure Torsion of a Magnesium–Manganese Alloy
Advanced Engineering Materials, EarlyView.An ultrafine‐grained alloy is produced by high‐pressure torsion of solutionized Mg–1.35 wt% Mn. Precipitation of nanometer‐scale Mn particles during deformation provides pinning sites. This prevents the formation of a bimodal grain structure and results in a finer grain size than for pure Mg.
Julian M. Rosalie, Anton Hohenwarter
wiley +1 more source