Results 61 to 70 of about 44,774 (227)
Intrazeolite phototopotaxy. EXAFS analysis of precursor 8{W(CO)6}-Na56Y and photooxidation products 16(WO3)-Na56Y and 28(WO3)-Na56Y [PDF]
The intrazeolite photooxidation chemistry of alpha-cage encapsulated hexacarbonyltungsten(0) in Na56Y with O2, denoted n{W(CO)6}-Na56Y/O2/hv, which has previously been shown to provide a novel synthetic pathway to alpha-cage located tungsten(VI) oxide ...
Bein, Thomas +3 more
core +1 more source
This study develops a novel atomic engineering strategy to fine‐tune the spin state of α‐Fe2O3 catalysts toward a medium‐spin state, thereby modulating peroxymonosulfate activation and selectively yielding surface‐bound radicals. Compared with free radicals, surface‐bound radicals exhibit moderated oxidation potential, extended lifespan, surface ...
Shuyu Wang +7 more
wiley +1 more source
Effectiveness of ab initio molecular dynamics in simulating EXAFS spectra from layered systems
The simulation of EXAFS spectra of thin films via ab initio methods is discussed. The procedure for producing the spectra is presented as well as an application to a two-dimensional material (WSe2) where the effectiveness of this method in reproducing ...
F. d'Acapito, M. A. Rehman
doaj +1 more source
A temperature-dependent EXAFS investigation of La{1-x}Ca{x}MnO3 is presented for the concentration range that spans the ferromagnetic-insulator (FMI) to ferromagnetic-metal (FMM) transition region, x = 0.16-0.22. The samples are insulating for x = 0.16-0.
A. Bianconi +7 more
core +1 more source
Atomically engineered layered 2D Ti3CNTz carbonitride MXene exhibits ultrahigh heat and pressure sensitivity, enabling dual‐mode sensors with 300%–400% performance enhancement and durability for real‐time health‐monitoring interface devices. Precise nitrogen incorporation (e.g., Ti3C1.8N0.2Tz) boosts conductivity, enhancing temperature response, while ...
Debananda Mohapatra +12 more
wiley +1 more source
Improving sensitivity of XANES structural fit to the bridged metal–metal coordination
Hard X-ray absorption spectroscopy is a valuable in situ probe for non-destructive diagnostics of metal sites. The low-energy interval of a spectrum (XANES) contains information about the metal oxidation state, ligand type, symmetry and distances in the ...
S. V. Abrosimov +9 more
doaj +1 more source
Neutron and X-ray diffraction studies on complex liquids [PDF]
The above examples illustrate the extent to which present day neutron and X-ray diffraction methods are being used to determine interatomic structure in a wide range of liquid and amorphous systems.
Adya, Ashok K. +2 more
core +3 more sources
Two pyridinium‐based ionic liquid templated hybrid manganese halides, (C4Py)2[MnCl4] and (C4Py)2[MnBr4], display similar bulk structures but show significantly different photoluminescence behaviors due to the bromine heavy‐atom effect. Their stable local Mn environments remain intact even in the molten state, allowing applications such as luminescence ...
Biswajit Bhattacharyya +22 more
wiley +1 more source
The EXAFS/XANES, XRD, SEM methods were used for examination of freshly prepared low temperature carbon monoxide oxidation in air catalyst PdCl2-CuCl2/γ-Al2O3 active components states.
D. N. Titov +7 more
doaj
Studies of Vibrational Properties in Ga Stabilized d-Pu by Extended X-ray Absorption Fine Structure
Temperature dependent extended x-ray absorption fine structure (EXAFS) spectra were measured for a 3.3 at% Ga stabilized Pu alloy over the range T= 20 - 300 K at both the Ga K-edge and the Pu L_III-edge.
A. L. Henderson +30 more
core +2 more sources

