Results 111 to 120 of about 129,573 (339)
ESTUDIO DE LAS PROPIEDADES DE UN SENSOR DE FIBRA ÓPTICA TIPO FABRY-PÉROT
Anales (Asociación Física Argentina), 2004 Un dispositivo Fabry-Pèrot (FP) de baja reflectividad, construido con los terminales de dos fibras ópticas,fue utilizado como espejo en un emisor superradiante basado en el empleo de una fibra óptica dopada conerbio.
Gustavo Arenas +3 more
doaj
A High Sensitivity Temperature Sensing Probe Based on Microfiber Fabry-Perot Interference
Italian National Conference on Sensors, 2019 In this paper, a miniature Fabry-Perot temperature probe was designed by using polydimethylsiloxane (PDMS) to encapsulate a microfiber in one cut of hollow core fiber (HCF). The microfiber tip and a common single mode fiber (SMF) end were used as the two
Zhoubing Li +4 more
semanticscholar +1 more source
A Multi‐Resonant Tunable Fabry‐Pérot Cavity for High Throughput Spectral Imaging
Advanced Optical Materials, Volume 13, Issue 8, March 13, 2025.This study introduces a multi‐resonant tunable Fabry‐Pérot filter for high throughput spectral imaging. With a spectral resolution of 10 nm and a switching time of 23 ms, this compact and low‐cost device possesses better spectral imaging accuracy in poor light conditions while maintaining over six times higher optical throughput than standard liquid ...
Xiao Wu +5 more
wiley +1 more source
Demonstration of 3-port grating phase relations
, 2006 We experimentally demonstrate the phase relations of 3-port gratings by investigating 3-port coupled Fabry-Perot cavities. Two different gratings which have the same 1st order diffraction efficiency but differ substantially in their 2nd order diffraction
A. Bunkowski +12 more
core +1 more source
Responsive Visible‐Wavelength Metasurfaces from Porous Silicon Based on Fano Guided‐Mode Resonance
Advanced Optical Materials, EarlyView.The article introduces mesoporous silicon metasurfaces (pSi‐MS) supporting Fano guided‐mode resonances in the visible regime. By combining top‐down lithographic patterning of 2D gratings with bottom‐up electrochemical porosification, the approach realizes a new class of responsive metasurfaces, enabling highly sensitive and portable platforms for small
Tomoshree Dash +4 more
wiley +1 more source
Advanced Optical Materials, EarlyView.Incorporating lanthanide‐based fluorophores into commercial resists for femtosecond direct laser writing enables a novel platform for multiplexed sensing. Porous, periodic, and solid luminescent microstructures fabricated directly on optical fiber tips are presented.
Valese Aslani +8 more
wiley +1 more source
, 2017 The aim of this paper is to present the first data set obtained with SOAR Adaptive Module-Fabry-Parot (SAM-FP), a Fabry-Perot instrument mounted inside the SOAR telescope Adaptive-Optics Module.
Amram, Philippe +5 more
core +3 more sources
Infrared Colloidal Quantum Dot Edge Emitting Lasers Integrated on Silicon
Advanced Optical Materials, EarlyView.In this work, the first monolithic integration of Pb‐chalcogenide CQDs in an edge‐emitting DFB laser cavity onto a Si/SiO2 substrate has been demonstrated. The optimizations of SiO2 layer thickness, engineering of the grating duty cycle, and implementing λ/4 phase shift resulted in the achievement of spectrally pure, single‐mode lasing at 1650 nm with ...
Hamed Dehghanpour Baruj +5 more
wiley +1 more source
AIP Advances, 2018 The modulation capability of a terahertz dynamic metasurface was enhanced by integrating it with an asymmetric Fabry-Pérot cavity. The dynamic metasurface consists of split ring resonators combined with high frequency metal semiconductor metal varactors.
Gyejung Lee +4 more
doaj +1 more source
SUNLITE program. Sub-Hertz relative frequency stabilization of two diode laser pumped Nd:YAG lasers locked to a Fabry-Perot interferometer [PDF]
Two laser pumped Nd:YAG lasers were frequency stabilized to a commercial 6.327 GHz free spectral range Fabry-Perot interferometer yielding a best case beatnote linewidth of 330 MHz.
Byer, R. L.
core +1 more source