Results 51 to 60 of about 16,230 (293)
Photothermal effects in ultra-precisely stabilized tunable microcavities
, 2016 We study the mechanical stability of a tunable high-finesse microcavity under ambient conditions and investigate light-induced effects that can both suppress and excite mechanical fluctuations.
Brachmann, Johannes F. S. +3 more
core +1 more source
Calculating the Fine Structure of a Fabry-Perot Resonator using Spheroidal Wave Functions [PDF]
, 2010 A new set of vector solutions to Maxwell's equations based on solutions to the wave equation in spheroidal coordinates allows laser beams to be described beyond the paraxial approximation.
Kuhn +11 more
core +3 more sources
Interferometry and Laser Control with Solid Fabry-Perot Etalons [PDF]
, 1966 The use and analysis of solid Fabry-Perot etalons for interferometry and laser control are discussed and supported with experimental data. Low angle scattering is found to be an important factor influencing finesse and peak transmission.
Peterson, Don G., Yariv, Amnon
core +1 more source
, 1981 Trace gases in the upper atmosphere can be measured by comparing spectral noise content of limb soundings with the spectral noise content of cold space. An offset Cassegrain antenna system and tiltable input mirror alternately look out at the limb and up
Gustincic, J. J.
core +1 more source
Multimode optomechanical system in the quantum regime
, 2016 We realise a simple and robust optomechanical system with a multitude of long-lived ($Q>10^7$) mechanical modes in a phononic-bandgap shielded membrane resonator.
Møller, Christoffer B. +4 more
core +1 more source
Cavity cooling of a nanomechanical resonator by light scattering [PDF]
, 2008 We present a novel method for opto-mechanical cooling of sub-wavelength sized nanomechanical resonators. Our scheme uses a high finesse Fabry-Perot cavity of small mode volume, within which the nanoresonator is acting as a position-dependant perturbation
Bhattacharya M Uys H Meystre P +10 more
core +1 more source
Study Of A Fabry-Perot Resonator
, 2013 A laser is essentially an optical oscillator consisting of a resonant cavity, an amplifying medium and a pumping source. In semiconductor diode lasers, the cavity is created by the boundary between the cleaved face of the semiconductor crystal and air, and has reflective properties as a result of the differing refractive indices of the two media. For a
F. Hadjaj +4 more
openaire +1 more source
Self‐Hybridized Exciton‐Polariton Photodetectors From Layered Metal‐Organic Chalcogenolates
Advanced Functional Materials, EarlyView.Self‐hybridized exciton‐polariton photodetectors are demonstrated using high refractive index mithrene, eliminating the need for top mirrors. This simplified architecture enables tunable sub‐bandgap photodetection via lower exciton‐polariton states and enhanced carrier transport through ultrafast polariton group velocities.
Bongjun Choi +3 more
wiley +1 more source
High-Q Fabry–Pérot Micro-Cavities for High-Sensitivity Volume Refractometry
Micromachines, 2018 This work reports a novel structure for a Fabry–Pérot micro cavity that combines the highest reported quality factor for an on-chip Fabry–Pérot resonator that exceeds 9800, and a very high sensitivity for an on-chip volume refractometer based on a Fabry ...
Noha Gaber +4 more
doaj +1 more source
, 2015 We consider a simple configuration for realizing one-dimensional slow-light metamaterials with large bandwidth-delay products using stub-shaped Fabry-Perot resonators as building blocks.
Bozhevolnyi, Sergey I., Raza, Søren
core +1 more source