Results 51 to 60 of about 70,244 (209)
STUDY ON CRACK PROPAGATION RATE UNDER FATIGUE LOAD
Jixie qiangdu, 2017 In this article,the new manifestation of crack propagation rate formula has been mainly studied when fatigue loads with diverse stress ratio and frequency acting on component with cracks. Linear and elastic crack propagation rate under fatigue loads with
YANG DaPeng +3 more
doaj
Application of numerical method to investigation of fatigue crack behavior through the friction stir welding [PDF]
, 2009 Fatigue crack propagation through a friction stir welded (FSW) joint of 2024-T351 Al alloy is investigated numerically. The governing relationships for predicting the crack behavior including incremental crack length, crack growth rate, and crack growth ...
Ali, Aidy, Golestaneh, Amirreza Fahim
core +1 more source
Fatigue Crack Initiation and Propagation [PDF]
, 2019 The resistance of metal alloys to fatigue can be classified into four major regimes: low-cycle fatigue (or short life), limited resistance (between 10^5 and 10^6 cycles), high-cycle fatigue (between 10^6 and 10^7 cycles) and gigacycle (more than10^7 cycles).
Doquet, Véronique +3 more
openaire +2 more sources
An approach to metal fatigue [PDF]
Cumulative fatigue damage based on investigation of fatigue limit associated with crack, crack propagation rate, and stress interaction cycle in ...
Redfern, J. H. +2 more
core +1 more source
Jixie qiangdu, 2023 In order to study the fatigue crack propagation of the fuselage skin under uniform pressurized cyclic load, experiments were carried out with the self-made aircraft fuselage skin uniform pressurized fatigue device.
LIU LiPing +4 more
doaj
Fatigue crack growth in thin notched woven glass composites under tensile loading. Part I: experimental [PDF]
, 2011 Helicopter blades are made of composite materials mainly loaded in fatigue and have normally relatively thin skins. A through-the-thickness crack could appear in these skins.
Barrau, Jean-Jacques +3 more
core +3 more sources
Environmental fatigue of an Al-Li-Cu alloy. Part 3: Modeling of crack tip hydrogen damage [PDF]
Environmental fatigue crack propagation rates and microscopic damage modes in Al-Li-Cu alloy 2090 (Parts 1 and 2) are described by a crack tip process zone model based on hydrogen embrittlement. Da/dN sub ENV equates to discontinuous crack advance over a
Gangloff, Richard P., Piascik, Robert S.
core +1 more source
Analysis of fatigue, fatique-crack propagation, and fracture data [PDF]
Analytical methods have been developed for consolidation of fatigue, fatigue-crack propagation, and fracture data for use in design of metallic aerospace structural components.
Davies, K. B. +3 more
core +1 more source
Crack initiation and early propagation behavior of AlSi10Mg(Cu) cast alloy under thermal fatigue
Cailiao gongcheng, 2019 The damage evolution under thermal fatigue loading for AlSi10Mg(Cu) cast alloy on the crack initiation and early propagation stage, mainly focusing on the influence of silicon particles on the thermal fatigue crack behaviour.
ZHOU Hang, ZHANG Zheng
doaj +1 more source
, 1973 Anti-buckling assembly prevents buckling of sheet metal fatigue specimen when axial compressive load is applied. It provides for cyclic heating and cooling of specimen during testing. Assembly permits tests at two locations on specimen.
Eichenbrenner, F. E., Imig, L. A.
core +1 more source