Multiscale fatigue damage characterization in short glass fiber reinforced polyamide-66 [PDF]
, 2014 This paper aims at studying fatigue damage behavior of injection molded 30 wt% short glass fiber reinforced polyamide-66 composite (PA66/GF30). The evolution of dynamic modulus, hysteresis area, cyclic creep and temperature during fatigue tests were ...
ARIF, Muhamad Fatikul +5 more
core +1 more source
High cycle fatigue damage mechanisms in cast aluminium subject to complex loads [PDF]
, 2013 Lien vers la version éditeur: http://www.sciencedirect.com/science/article/pii/S0142112312002356This article is dedicated to the high cycle fatigue behaviour of cast hypo-eutectic Al–Si alloys. In particular, the AlSi7Cu05Mg03 alloy is investigated.
AUGUSTINS, Louis +4 more
core +1 more source
Non-local energy based fatigue life calculation method under multiaxial variable amplitude loadings [PDF]
, 2013 Reliable design of industrial components against high cycle multiaxial fatigue requires a model capable of predicting both stress gradient and load type effects. Indeed, taking into account gradient effects is of prior importance for the applicability of
PALIN-LUC, Thierry +4 more
core +1 more source
On the multiaxial fatigue assessment of complex three-dimensional stress concentrators [PDF]
, 2014 This paper assesses and quantifies the detrimental effects of complex tri-dimensional notches subjected to uniaxial and multiaxial fatigue loading. A number of experimental results taken from the technical literature and generated by testing specimens ...
ASKES, Harm +4 more
core +1 more source
Creep–Fatigue Life Estimation of Gr.91 Steel and Its Welded Joints
Metals, 2023 A series of creep–fatigue tests of Gr.91 steel were performed at 600 °C. Fatigue life was reduced by tensile strain holding. The minimum life reduction factor was approximately 0.3.
Isamu Nonaka
doaj +1 more source
Properties evolution of flax/epoxy composites under fatigue loading [PDF]
, 2014 The tension–tension fatigue behaviour of flax fibre reinforced epoxy matrix composites have been investigated for specimens having [0]12, [90]12, [0/90]3S and [±45]3S lay-ups.
GNING, Papa-Birame +2 more
core +1 more source
Linear Damage Rule Life Prediction for Stress Controlled Fatigue-Creep Interaction of Aluminum Alloys [PDF]
Engineering and Technology Journal, 2012 The fatigue-creep interaction performance of 5086 and 6061-T651 aluminum alloys were investigated for specimens tested under control stress rotating bending at a stress ratio R=-1 and 250°C temperature. The fatigue endurance limit for both alloys reduced
Salah F. Abd-El-Jabbar +2 more
doaj +1 more source
Buildings, 2022 In this paper, the rib beam bridge slabs were taken as the research object. Static load and fatigue tests were carried out on the benchmark bridge slabs to determine the ultimate load capacity and fatigue life of the bridge slabs.
Yifan Wang +5 more
doaj +1 more source
Fatigue crack growth in thin notched woven glass composites under tensile loading. Part II: modelling [PDF]
, 2011 Fatigue propagation of a through-the-thickness crack in thin woven glass laminates is difficult to model when using homogeneous material assumption. Crack growth depends on both the fatigue behaviour of the fibres and of the matrix, these two phenomena ...
Barrau, Jean-Jacques +7 more
core +1 more source
A new cyclic cohesive zone model for fatigue damage analysis of welded vessel
Theoretical and Applied Mechanics LettersA new cyclic cohesive zone fatigue damage model is proposed to address the fatigue problem spanning high and low cycle stages. The new damage model is integrated with the damage extrapolation technique to improve calculation efficiency.
Changyuan Shen +3 more
doaj +1 more source