Results 1 to 10 of about 11,373,640 (309)
Testing Sensitivity of A-Type Residual Current Devices to Earth Fault Currents with Harmonics [PDF]
In many applications, modern current-using equipment utilizes power electronic converters to control the consumed power and to adjust the motor speed. Such equipment is used both in industrial and domestic installations.
S. Czapp
semanticscholar +2 more sources
The discrimination of inrush currents and internal fault currents in transformers is an important feature of a transformer protection scheme. The harmonic current restrained feature is used in conventional differential relay protection of transformers. A
Sunil Kumar Gunda +1 more
doaj +2 more sources
This article puts forward a new algorithm based on Kullback–Leibler divergence (KLD) for discriminating inrush and internal fault currents in power transformers.
Mohsen Tajdinian, H. Samet
semanticscholar +1 more source
The paper analyses how the characteristics of the medium-voltage network with insulated neutral and the conditions under which the single line-to-ground fault occurs (insulation condition and value of the fault resistance) influence the zero-sequence ...
Dumitru Toader +4 more
doaj +1 more source
Open-Circuit Fault-Tolerant Control of Multi-Phase PM Machines by Compensating the d-q Axes Currents
This paper presents a novel method to control sinusoidal distributed winding or sinusoidal back electromotive force (back-EMF) multi-phase permanent magnet (PM) machines under open-circuit fault conditions.
Ali Akay, Paul Lefley
doaj +1 more source
DC short-circuit faults are one of the challenges for modular multilevel converter (MMC) based DC grid. It is vital for proper design of protection system to estimate the fault currents and voltages.
Hui Cai +3 more
doaj +1 more source
The increasing integration of Power Electronics (PE)-based renewable energy sources into the electric power system has significantly affected the traditional levels and characteristics of fault currents compared to the ones observed in power systems ...
Rafat Aljarrah +6 more
doaj +1 more source
The use of phase voltage modules to select the damaged phase in case of single-phase earth faults
In case of short circuits, the selection of damaged phases always precedes the determination of the damage location. To select the damaged phase, filter selector of the damaged phase are widely used, using symmetrical components of phase currents.
V. A. Shabanov, A. V. Sorokin
doaj +1 more source
Fault analysis is an essential prerequisite for fault detection, location and isolation. A detailed fault analysis method on the steady state of the pole‐to‐pole fault for voltage source converter (VSC) based DC systems is presented in this paper ...
Zhengguang Xiao +4 more
doaj +1 more source
A New Theory for Locating Line Fault in Power System: Simulation Part
Three time-reversal-based fault location methods are derived from the theoretical part of this paper, which is named currents-in-time-domain method, forward-currents-in-frequency-domain method, and forward-currents-in-frequency-domain-with-compensation ...
Xipeng Zhang +5 more
doaj +1 more source

