Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Humic Acid-Stabilized Biogenic FeS Nanoparticles for Cr(VI) Removal Under Simulated Acidic Mine Drainage Conditions: Optimization and Interfacial Transformation Pathways. [PDF]
Dai M, Di J, Zhang M.
europepmc +1 more source
Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio
This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov +4 more
wiley +1 more source
Peripheral immune and kynurenine profiles are associated with cognitive change during early treatment of first-episode schizophrenia. [PDF]
Tang JL, Xu FF, Wu L.
europepmc +1 more source
Carbon‐free inert anodes are essential for decarbonizing aluminum electrolysis. This study investigates a recyclate‐based MgO‐316L steel composite anode tested under galvanostatic Hall–Héroult conditions in cryolite at 1000°C. Microstructural analysis reveals selective MgO fluorination, spinel and oxide layer formation, electrolyte infiltration, and ...
Serhii Yaroshevskyi +7 more
wiley +1 more source
Interfaced FeS/g-C<sub>3</sub>N<sub>4</sub> hybrid material for charge transport in supercapacitors. [PDF]
Ahmad S +9 more
europepmc +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
Facile synthesis of FeS-Fe<sub>3</sub>O<sub>4</sub> nanocomposites: highly stable & enhanced electrochemical performance in asymmetric supercapacitor applications. [PDF]
Riaz J +4 more
europepmc +1 more source
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Hafnium-Based Ferroelectric Post-Moore Electronics: Device Physics, Integration Architectures, and Neuromorphic System Implementation. [PDF]
Chen X, Wang Z, Meng J, Wang T.
europepmc +1 more source

