Results 1 to 10 of about 28,956 (117)
Comparison of 1480 nm and 980 nm-pumped Gallium-Erbium fiber amplifier [version 2; peer review: 1 approved, 2 approved with reservations] [PDF]
Background: One way to reduce the length of the gain medium in Erbium-Doped Fiber Amplifier (EDFA) is by doping the fiber core with a high concentration of Erbium.
Tuan Ainin Sofea Tuan Mohd Marzuki +4 more
doaj +2 more sources
Experimental study on the 500-W-level all-fiber amplifier operating near 980 nm
In this paper, a 500-W-level all-fiber amplifier operating near 980 nm is demonstrated firstly, to the best of our knowledge. The amplifier is fabricated with a 105/250-μm core/cladding-diameter double-cladding Yb-doped fiber (DCYF).
Maoni Chen +6 more
doaj +3 more sources
Fiber Residual Stress Effects on Modal Gain Equalization of Few-Mode Fiber Amplifier [PDF]
Bing Bai, Li Pei, Jingjing Zheng
exaly +2 more sources
We present a low-intensity noise single-frequency Yb-doped all-fiber amplifier oriented to space-borne gravitational wave detection. Relative intensity noise (RIN) below −70 dBc/Hz @ 1 mHz~1 Hz was achieved by virtue of feedback-loop-based intensity ...
Zaiyuan Wang +5 more
doaj +1 more source
STUDY OF GAIN FACTOR EFFECT OF ERBIUM DOPED FIBER AMPLIFIER ON NOISE FLOOR LEVEL OF FIBER-OPTIC INTERFEROMETRIC SENSOR [PDF]
Subject of Research. The paper presents experimental study results of the gain factor effect of an erbium doped fiber amplifier on the noise floor level of a fiber-optic interferometric acoustic sensor.
M. V. Bykadorov +3 more
doaj +1 more source
In this paper we experimentally demonstrate a femtosecond all-polarization- maintaining laser amplifier in an all-fiber scheme, which consists of a mode-locked oscillator and a two-stage amplifier.
Kuo Meng +3 more
doaj +1 more source
Raman Assisted Fiber Optical Parametric Amplifier for S-Band Multichannel Transmission System
In this paper we present results from the study of optical signal amplification using Raman assisted fiber optical parametric amplifier with considerable benefits for S-band telecommunication systems where the use of widely used erbium-doped fiber ...
Andis Supe +6 more
doaj +1 more source
Thermally Induced Mode Amplification Characteristics of Large Mode Area Segmented Cladding Fiber
A model of amplifier based on large mode area (LMA) segmented cladding fiber (SCF) is proposed. High order modes (HOMs) filtering effect and thermal-induced modal evolution characteristics are theoretically investigated by the few-mode steady state rate ...
Caijian Xie +6 more
doaj +1 more source
A hybrid double cladding erbium–ytterbium co-doped fiber (EYDF) amplifier with a single-mode-multimode-single-mode (SMS) active fiber is demonstrated in this study.
Xiaolei Bai +4 more
doaj +1 more source
Flattening Few Mode Fiber Laser Source Based on PMF and Loop Mirror in a Ring Cavity Resonator [PDF]
: A multi-wavelength source using a hybrid amplifier comprised of a Semiconductor Optical Amplifier (SOA) and an Erbium-doped fiber amplifier (EDFA) in a ring fiber laser set up is proposed. Multi-wavelength sources are less expensive and more efficient
Sharifeh Shahi
doaj +1 more source

