Results 121 to 130 of about 56,321 (268)

Highly Versatile Real‐Time Optical Noise Filtering Through Temporal Cloaking

open access: yesLaser &Photonics Reviews, EarlyView.
Conventional bandpass filtering strategies may be insufficient for recovering optical waveforms under extremely noisy conditions. We demonstrate a temporal‐cloaking denoising strategy enabled by the temporal Talbot effect, which concentrates the coherent signal of interest into short temporal slots while broadband noise remains temporally spread.
Majid Goodarzi   +5 more
wiley   +1 more source

Interrogation procedure for double addressed fiber Bragg structures as sensors of radiophotonic fewsensor system

open access: yesФизика волновых процессов и радиотехнические системы, 2018
Microwave photonic sensor systems represent a wide class of information systems with measurement conversion that use standardized analog and parallel links of parallel and sequential type with filtering, allowing to functionally displaying the ...
A.Zh. Sakhabutdinov, O.G. Morozov
doaj  

Residual strain monitoring during composite manufacturing [PDF]

open access: yes, 2012
This work explores a new possibility in accurate measurement of multi-axial residual strains during the production of composite structures. It investigates the usability of the polarization dependent loss (PDL) of an optical fibre Bragg grating as a ...
Caucheteur, Christophe   +5 more
core   +1 more source

Exploring Thermal and Mechanical Strains During Laying Down Process in Fused Filament Fabrication

open access: yesMacromolecular Materials and Engineering, EarlyView.
This study analyzes strain evolution and thermal behavior during FFF of PLA using strain gauges and infrared imaging. Microstrain levels depend on printing conditions, with adhesion‐induced compression during cooling and peak strains in early layers. Microtomography shows minimal porosity, while thermal imaging reveals rapid heat penetration, strong ...
Boubakeur Mecheri   +3 more
wiley   +1 more source

Strain Development During Cure of Partially Pre‐Cured Thermosetting Composites Measured With Distributed Fiber Optic Sensors

open access: yesPolymer Composites, EarlyView.
Schematic representation of the beneficial effect of ply pre‐curing on temperature overshoot, internal strain and warpage during cure of thin and thick thermosetting composites. ABSTRACT Detection of manufacturing‐induced defects in thermosetting composites is crucial to guarantee part quality, safety, and improve manufacturing efficiency.
Francesco Taddei   +3 more
wiley   +1 more source

Unlocking Klockmannite: Formation of Colloidal Quasi‐2D CuSe Nanocrystals and Photo‐Physical Properties Arising From Crystal Anisotropy

open access: yesSmall, EarlyView.
Thiol‐free hot injection approach yields quasi‐2D klockmannite CuSe nanocrystals, specifically nanosheets and uniform triangular nanoplatelets. This study reconsiders the klockmannite from the point of view of crystal anisotropy and demonstrates its effect on plasmonic response in the near‐infrared spectral region with the theoretical emergence of ...
Urvi Parekh   +10 more
wiley   +1 more source

Effect of radiation and temperature on high temperature resistant fiber Bragg gratings

open access: green, 2022
Thomas Blanchet   +12 more
openalex   +2 more sources

Evaluation of prestress losses in concrete beams using destructive and non‐destructive methods

open access: yesStructural Concrete, EarlyView.
Abstract Over the past few decades, prestressing techniques have become essential in the construction of key structures, infrastructure, and bridges. The serviceability and safety of prestressed concrete (PC) elements are closely tied to the effectiveness of the prestressing process.
A. N. Consiglio, G. Muciaccia, G. Rosati
wiley   +1 more source

Home - About - Disclaimer - Privacy