Results 11 to 20 of about 236,033 (259)
Simultaneous Dual Band Transmission Over Multimode Fiber-Fed Indoor Wireless Network [PDF]
, 2006 Performance measurements of different combinations of digital enhanced cordless telecommunications packet radio service, global system for mobile communications, universal mobile telecommunication service, and 802.11g (54 Mbps) signals in a dual band ...
Lethien, Christophe +7 more
core +1 more source
Hierarchical fiber bundle strength statistics [PDF]
, 2012 Multi-scale modeling is currently one of the most active research topics in a wide range of disciplines. In this thesis we develop innovative hierarchical multi-scale models to analyze the probabilistic strength of fiber bundle structures.
Alsaeed Mahmoud Abdalrahman, Tamer
core +1 more source
, 2014 The fiber with gradually changing diameter was fabricated by changing the draw ratio continuously, that is, by changing the take-up speed of melt spinning, laser drawing, and heater drawing processes.
伊藤, 章喜 +3 more
core +1 more source
Photonic crystal fiber half-taper probe based refractometer [PDF]
, 2014 A compact singlemode - photonic crystal fiber - singlemode fiber tip (SPST) refractive index sensor is demonstrated in this paper. A CO2 laser cleaving technique is utilised to provide a clean-cut fiber tip which is then coated by a layer of gold to ...
Bo, Lin +8 more
core +1 more source
Fibrin Fiber Stiffness Is Strongly Affected by Fiber Diameter, but Not by Fibrinogen Glycation [PDF]
Biophysical Journal, 2016 The major structural component of a blood clot is a mesh of fibrin fibers. Our goal was to determine whether fibrinogen glycation and fibrin fiber diameter have an effect on the mechanical properties of single fibrin fibers. We used a combined atomic force microscopy/fluorescence microscopy technique to determine the mechanical properties of individual
Li, Wei +6 more
openaire +3 more sources
MEASUREMENT OF FIBER DIAMETERS BY THE DIFFRACTION METHOD
Review of Scientific Instruments, 1931 The classification of wool fibers into standard grades is based entirely on the average diameter of the fibers. The diffraction of light by a bundle of parallel fibers was employed by Thomas Young in 1824 in a simple ingenious instrument for the rapid direct measurement of average diameter, but no thorough investigation has ever been made of the ...
H.J McNicholas, H.J. Curtis
openaire +1 more source
Optical fibre nanowires and related structures [PDF]
, 2007 The fabrication of optical fibre nanowires by flame-brushing represents a top-down method to reliably manufacture the longest, most robust nanowires from silica and compound glasses.
Brambilla, Gilberto +3 more
core +1 more source
Ultra-Fine fibers Produced by Laser-Electrospinning [PDF]
, 2008 We used a CO2 laser as a heat source to avoid thermodegradation in the melt-electrospinning process (termed “laser electrospinning” (LES)). Nylon 6, polypropylene, poly (ethylene terephthalate) and poly (L-lactide-co-ε-caprolactone) fiber webs were ...
Ohkoshi, Y +4 more
core +1 more source
Electrospinning of poly (ether sulfone) and evaluation of the filtration efficiency [PDF]
, 2007 To produce high heat-resistant air filter, filtration properties of poly (ether sulfone) (PES) made by various electrospinning conditions were evaluated.
Ohkoshi, Y +4 more
core +1 more source
, 2008 Results of an investigation of the mechanical performance of injection moulded long glass fibre-reinforced polyamide 6,6 composites are presented. The glass fibre content in these composites was varied over the range 10-50% by weight using fibres with ...
Thomason, J.L., J.L. Thomason
core +1 more source