Results 131 to 140 of about 1,181 (214)
Knee Surgery, Sports Traumatology, Arthroscopy, EarlyView.Abstract Purpose To evaluate the failure rates of all‐inside meniscal repair based on tear morphology in stable knees (i.e., without concomitant anterior cruciate ligament reconstruction [ACLR]) and to assess the influence of failure. Methods This retrospective cohort study included 1008 patients who underwent arthroscopic all‐inside meniscal repair ...
Christoffer von Essen +3 more
wiley +1 more source
Knee Surgery, Sports Traumatology, Arthroscopy, EarlyView.Abstract Acute, traumatic meniscus tears are common and should be repaired whenever possible. However, the biological age of the patient, along with the specific tear morphology, may significantly influence the selection of the repair technique, expected clinical outcomes and the postoperative rehabilitation protocol.
Armin Runer +15 more
wiley +1 more source
Knee Surgery, Sports Traumatology, Arthroscopy, EarlyView.Abstract Purpose To determine the failure rate and identify factors associated with failure following all‐inside revision meniscal repair in patients with persistent or recurrent symptoms after primary meniscal repair. Methods This was a retrospective cohort study including 108 consecutive patients who underwent arthroscopic all‑inside revision ...
Christoffer von Essen +4 more
wiley +1 more source
Controlling the Center of Mass Motion of Levitated Particles Using Structured Wavefronts
Laser &Photonics Reviews, EarlyView.Optically levitated particles have great potential for quantum‐enhanced sensing. Precise control of the trapping beam is crucial to improve the stability and confinement of these systems. Here, we study how structured wavefronts can be used to control the center‐of‐mass motion of levitated particles, enhancing trap stiffness and enabling stable ...
Shah Jee Rahman +7 more
wiley +1 more source
Grating‐Lens Empowered Metafiber for Large‐Angle Light Collection With 3D Nanoprinted Structures
Laser &Photonics Reviews, EarlyView.A grating‐lens‐based Metafiber enables efficient light coupling into single‐mode fibers at large incidence angles. By combining diffraction and focusing on the fiber facet using a 3D nanoprinted holographic structure, light is selectively coupled only at specific angles while suppressing unwanted signals. This approach achieves high coupling efficiency
Jun Sun, Markus A. Schmidt
wiley +1 more source
Laser &Photonics Reviews, EarlyView.An etchless lithium niobate (LN) metasurface with a slanted periodic TiO2 grating enables efficient and narrowband second‐harmonic generation (SHG) thanks to the light confinement in the LN film granted by quasi‐bound‐state‐in‐the‐continuum (q‐BIC) modes.
Yaping Hou +10 more
wiley +1 more source
1 W Single‐Mode Large‐Area Edge‐Emitting Laser via Non‐Hermitian Spatial Mode Filtering
Laser &Photonics Reviews, EarlyView.We demonstrate a non‐Hermitian spatial mode filtering approach for achieving high‐power single‐mode operation in large‐area edge‐emitting laser diodes. By symmetrically coupling passive filter arrays to the main lasing waveguide, higher‐order transverse modes are effectively suppressed while preserving the fundamental mode.
Ece Karabey +4 more
wiley +1 more source
Parallel Multi‐Target Detection for Quantum LiDAR
Laser &Photonics Reviews, EarlyView.Parallel multi‐target detection is achieved in quantum LiDAR with a single‐pixel quantum readout. Direction and distance information are extracted together, allowing multiple objects to be distinguished under noisy low‐light conditions and pointing to a new strategy for scan‐free quantum remote sensing.
Junyeop Kim +4 more
wiley +1 more source
Laser &Photonics Reviews, EarlyView.Chip‐based frequency combs are usually pumped from telecom wavelengths, far from the visible. This work instead pumps close to the visible with a Ti:sapphire laser ‐ the source behind the original optical frequency combs and now becoming chip‐integrable‐ and lets silicon‐nitride waveguides convert it into efficient, octave‐spanning visible‐to‐infrared ...
Abdullah Alabbadi +5 more
wiley +1 more source
Multifunctionality in Silicon Photonics Through Temperature‐Driven Inverse Design
Laser &Photonics Reviews, EarlyView.Temperature‐conditioned inverse design embeds thermo‐optic reconfigurability directly into compact silicon photonic devices. By co‐optimizing a single geometry at 300 K (T1) and 520 K (T2), the same structure supports distinct optical functions, enabling experimentally verified switching and mode conversion without resonant architectures or additional ...
Berkay Neseli +8 more
wiley +1 more source