Results 81 to 90 of about 66,325 (297)

Novel Method to Improve the Signal to Noise Ratio in the Far-field Results Obtained from Planar Near Field Measurements. [PDF]

open access: yes, 2010
A method to reduce the noise power in far-field pattern without modifying the desired signal is proposed. Therefore, an important signal-to-noise ratio improvement may be achieved.
Besada Sanmartin, Jose Luis   +3 more
core   +1 more source

Wireless Power Transfer for Distributed Estimation in Sensor Networks

open access: yes, 2017
This paper studies power allocation for distributed estimation of an unknown scalar random source in sensor networks with a multiple-antenna fusion center (FC), where wireless sensors are equipped with radio-frequency based energy harvesting technology ...
Ishibashi, Koji   +2 more
core   +1 more source

Linearity considerations in adaptive antenna array applications [PDF]

open access: yes, 1995
The use of adaptive antenna in mobile communications base stations is self-explanatory. It offers the potential of increased spectrum efficiency, extended range of coverage and reduced delay spread.
Beach, MA   +3 more
core   +2 more sources

Mechanochemical Synthesis and Characterization of Nanostructured ErB4 and NdB4 Rare‐Earth Tetraborides

open access: yesAdvanced Engineering Materials, Volume 27, Issue 6, March 2025.
ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur   +5 more
wiley   +1 more source

Dual-Polarized Wideband Filtering Antenna Array Based on Stacked-PCB Structure

open access: yesIEEE Open Journal of Antennas and Propagation
This paper investigates a thin low-pass filtering antenna array based on dual-polarized Vivaldi elements. The low-pass filtering in the antenna elements reduces the requirement for the front-end filtering between the antenna and the microwave electronics,
Matti Kuosmanen   +5 more
doaj   +1 more source

Dual-Polarized Low-Profile Filtering Patch Antenna Without Extra Circuit

open access: yesIEEE Access, 2019
This paper proposes a novel dual-polarized filtering patch antenna without an extra circuit. The proposed antenna shows a quasi-elliptic filtering response with four radiation nulls.
Yaohui Zhang   +4 more
doaj   +1 more source

Stub-loaded resonator-fed filtering patch antenna with improved bandwidth [PDF]

open access: yes, 2016
A method of designing a patch antenna with wideband and filtering characteristics is proposed in this paper. Different from traditional aperture-coupled patch antenna, a stub loaded resonator (SLR) is employed as the feed. This coupled SLR-patch produces
Gao, Steve, Mao, Chunxu, Wang, Yi
core   +1 more source

Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology

open access: yesAdvanced Engineering Materials, EarlyView.
We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham   +7 more
wiley   +1 more source

Filtenna Integration Achieving Ideal Chebyshev Return Losses [PDF]

open access: yes, 2014
This paper demonstrates that it is possible to find an ideal filter response (Chebyshew, Butterworth,..) considering the antenna as the last resonator of a filter under certain circumstances related with the antenna performance and the bandwidth of the ...
Collado, C.   +5 more
core   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Home - About - Disclaimer - Privacy