Results 121 to 130 of about 447,422 (304)
Shock and Vibration, 2015 The cemented coal gangue backfill (CGB) in coal mining is normally made of gangue (particle size of 0–15 mm), fly ash, cement, and water. In this study, the effects of the weight content (ranging from 20% to 60%) of fine gangue (0–5 mm) on the ...
Tingye Qi +5 more
doaj +1 more source
Control of volume resistivity in inorganic organic separators [PDF]
Control of resistivity in NASA inorganic-organic separators is achieved by incorporating small percentages of high surface area, fine particle silica with other ingredients in the separator coating.
Manzo, M. A., Sheibley, D. W.
core +1 more source
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Experimental study on the impact of water flow velocity on internal erosion of granite residual soil
Scientific ReportsThe internal erosion effect causes fine particles in the soil to move through seepage, and the loss of these fine particles leads to changes in porosity, which in turn affects the soil’s hydraulic properties and mechanical performance, posing a threat to
Shaofeng Wan +3 more
doaj +1 more source
Drying and Deposition of Picolitre Droplets of Colloidal Suspensions in Binary Solvent Mixtures [PDF]
, 2012 This work was supported by EPSRC grant number ...
Bain, CD +3 more
core
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
Evaluation of particle size distribution of granular blasting materials based on the fractal theory
Advances in Mechanical Engineering, 2019 The particle size distribution of granular blasting materials has a vital influence on the filling quality of earth-rockfill dams. The engineering experience-based method used to evaluate the particle size distribution has shortcomings at both the ...
Jiejie Ji +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio
Advanced Engineering Materials, EarlyView.This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov +4 more
wiley +1 more source
AgricultureTo investigate the impact of sediment on water infiltration and soil structure under muddy water irrigation conditions, indoor muddy water film hole infiltration experiments were conducted.
Youliang Peng +5 more
doaj +1 more source