Results 131 to 140 of about 447,422 (304)

Characterization of a Recyclate‐Based MgO‐Steel Composite As‐Sintered Inert Anode Candidate After Exposure to Cryolite Electrolysis

Advanced Engineering Materials, EarlyView.
Carbon‐free inert anodes are essential for decarbonizing aluminum electrolysis. This study investigates a recyclate‐based MgO‐316L steel composite anode tested under galvanostatic Hall–Héroult conditions in cryolite at 1000°C. Microstructural analysis reveals selective MgO fluorination, spinel and oxide layer formation, electrolyte infiltration, and ...
Serhii Yaroshevskyi, Alexander Adamczyk, Nora Brachhold, Gert Schmidt, Jana Hubálková, R. Gumeniuk, Alexandros Charitos, Christos G. Aneziris   +7 more
wiley   +1 more source

Research on online detection of particle size in fine-grained coal classification overflow

Gong-kuang zidonghua
Real time online detection of the particle size of the overflow in the selection and classification of fine-grained coal can be carried out, and the classification parameters can be adjusted to reduce the content of coarse particles in the overflow and ...
SUN Haozhi, MA Jiao, SHI Changliang, WANG Hanlu   +3 more
doaj   +1 more source

Техніка та технологія дезінтеграції й гравітаційного збагачення рідкіснометалічних руд [PDF]

, 2017
On the base of the analysis of centrifugal concentrators designs there has been justified the selection of apparatus for the rare-metal ores beneficiation.
Biletskyi, V. S., Komarova, O. I., Shpylovyi, K. L., Shpylovyi, L. V.   +3 more
core  

Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere

Advanced Engineering Materials, EarlyView.
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +2 more
wiley   +1 more source

Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics

Advanced Engineering Materials, EarlyView.
Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost, Lionel Presmanes, Soléna Colin, Marie Vidal, Sophie Guillemet‐Fritsch   +4 more
wiley   +1 more source

Experimental and analytical investigation of Frost heave characteristics in red-bed coarse-grained materials incorporating particle breakage effect

Scientific Reports
The eastern part of the Qinghai-Tibet Plateau is located in the high-altitude freeze-thaw region, where terrestrial clastic red beds formed by sedimentation since the Mesozoic are widely distributed. Recently, red-bed coarse-grained materials (CGMs) have
Xiao Han, Ruotong Sun, Shuang Tian, Xianzhang Ling, Jia’an Zou, Jingyi Liu, Xipeng Qin   +6 more
doaj   +1 more source

Mutagenicity assessment of aerosols in emissions from wood combustion [PDF]

, 2011
Mestrado em Estudos AmbientaisPolycyclic aromatic hydrocarbon (PAH) extracts of PM2.5 collected from combustion of seven wood species and briquettes were tested for mutagenic activities using Ames test with Salmonella typhimurium TA98 and TA100.
Binh Ngan Vu
core   +1 more source

Population of Nonmetallic Inclusions in Liquid High‐Silicon Electrical Steel in Contact With MgO–C Refractories Based on Recyclates and Environmentally Friendly Binders

Advanced Engineering Materials, EarlyView.
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert, Matheus Roberto Bellé, Florian Kerber, Dinesh Kumar Gunasekar, Hans‐Jörn Weddige, Christos G. Aneziris, Olena Volkova   +6 more
wiley   +1 more source

Features of electroweak symmetry breaking in five dimensional SUSY models

, 2015
We explore the phenomenological predictions of a supersymmetric standard model, with a large extra dimension and unifying gauge couplings. The modified five dimensional renormalisation group equations make it possible to obtain light, maximally mixed ...
Lalak, Zygmunt, Lewicki, Marek, McGarrie, Moritz, Olszewski, Paweł   +3 more
core   +1 more source

Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys

Advanced Engineering Materials, EarlyView.
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa, Aparna Saksena, Alesander Kostka, Pascal Thome, Felicitas Scholz, Alexandre Mussi, Christoph Somsen, Baptiste Gault, Jan Frenzel, Gunther Eggeler   +9 more
wiley   +1 more source