Results 111 to 120 of about 447,422 (304)
Application of Raman and Photoluminescence Spectroscopy to MgO‐C Refractories
Advanced Engineering Materials, EarlyView.Visible to near infrared luminescence of MgO is studied on MgO‐C bricks and nominally pure MgO powder, with focus on two similar sharp high‐intensity signals, at 699 and 871 nm, each surrounded by symmetrical sidebands. The nature of these sidebands is investigated by temperature‐dependent spectroscopic measurements, confirming phonon involvement by ...
Julia Richter +5 more
wiley +1 more source
Communications, 2000 The paper presents the analysis of fly ash influence on rheological properties of cement pastes with content different type of fly ash concerning particle size distribution.
Stefania Greszczyk, Grzegorz Lipowski
doaj +1 more source
The Feasibility of Reclaiming Shell Material from Investment Casting [PDF]
, 1992 This report examines the feasibility of investment shell component reclamation. Shell material components and their compositions are investigated with an industry survey, a study of the available literature, and analysis of specimen shell materials ...
Peters, Timothy M., Twarog, Daniel L.
core
Advanced Engineering Materials, EarlyView.Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios +5 more
wiley +1 more source
Evaluation of some ceramic clays from Zambia [PDF]
, 1993 This reports details the technical evaluation of ceramic clays collected during visits to Zambia in 1990 and 1991 by the author (Clive Mitchell). The clay samples included: Choma kaolin (Southern Province), Twapia kaolin (Copperbelt Province), Kapiri ...
Mitchell, C.J.
core
Advanced Engineering Materials, EarlyView.A hierarchical porous copper current collector is fabricated via three‐dimensional printing combined with pressureless sintering to stabilize lithium metal anodes. The interconnected architecture lowers local current density, guides uniform Li deposition within pores, and suppresses dendrite growth.
Alok Kumar Mishra, Mukul Shukla
wiley +1 more source
Quality of type I Portland cement from Ghana and UK [PDF]
, 2015 Type I Portland cement is general purpose cement found in many countries and it is manufactured by different companies. This study sought to compare the properties of Type I Portland cements from Ghana (less economically developed country) and United ...
Boateng, Isaac, Danso, Humphrey
core +2 more sources
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Soil Stabilization Manual 2014 Update [PDF]
, 2014 Soil Stabilization is used for a variety of activities including temporary wearing curses, working platforms, improving poor subgrade materials, upgrading marginal materials, dust control, and recycling old roads containing marginal materials. There are
Connor, Billy +2 more
core
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source