Results 81 to 90 of about 201,072 (202)
IEEE Access, 2020 In this article, a modified decentralized finite control set model predictive control (FCS-MPC) scheme for the distributed energy resources (DERs) is proposed to improve the power management quality of the prosumers integrated microgrids under the ...
Zhuoli Zhao +7 more
doaj +1 more source
Finite Control Set Model Predictive Control for Complex Energy System with Large-Scale Wind Power
Complexity, 2019 Complex energy systems can effectively integrate renewable energy sources such as wind and solar power into the information network and coordinate the operation of renewable energy sources to ensure its reliability.
Yang-Wu Shen +5 more
doaj +1 more source
Energies, 2019 In order to improve the dynamics of the surface-mounted permanent magnet synchronous motors (SPMSM) used in servo systems, finite control set model predictive current control (FCS-MPCC) methods have been widely adopted. However, because the FCS-MPCC is a
Zhicheng Liu, Yang Zhao
doaj +1 more source
Multistep finite-control-set model predictive control of active power filter
IOP Conference Series: Earth and Environmental Science, 2020 Abstract The traditional finite-control-set model predictive control (FCS-MPC) of three-phase active power filter (APF) has the problems of low compensation precision and long control delay. In order to address this problem, this paper proposes a multistep prediction compensation control method for the FCS-MPC of APF, it does not require
EnZi Bi +3 more
openaire +1 more source
Energies, 2020 In the paper a comparative study of the two control structures based on MPC (Model Predictive Control) for an electrical drive system with an induction motor are presented.
Karol Wróbel +2 more
doaj +1 more source
Predictive current control with instantaneous reactive power minimization for a four-leg indirect matrix converter [PDF]
, 2017 This paper presents the experimental valida¬tion of a predictive current control strategy with minimiza¬tion of the instantaneous reactive input power for a Four-Leg Indirect Matrix Converter (4Leg-IMC).
Garcia, Cristian F. +4 more
core +2 more sources
A Fault-Tolerant Two-Motor Drive With FCS-MP-Based Flux and Torque Control [PDF]
, 2014 Independently controlled multi-motor drives are typically realized by using a common dc link and independent sets of three-phase inverters and motors. In the case of an open-circuit fault in an inverter leg, one motor becomes single-phase.
Abd Rahim, N +4 more
core +2 more sources
A finite control set model predictive control based hybrid PWM technique
2015 IEEE International Conference on Industrial Technology (ICIT), 2015 Hybrid Pulse Width Modulation (PWM) techniques select the appropriate PWM sequence that induces either less current distortion or less switching losses or both. The sequence selection is usually based on an off-line sector partitioning. This simple solution freezes unfortunately the design and prevents any on-line evolution.
Gendrin, Martin +2 more
openaire +2 more sources
Distributed Model Predictive Consensus via the Alternating Direction Method of Multipliers [PDF]
, 2012 We propose a distributed optimization method for solving a distributed model predictive consensus problem. The goal is to design a distributed controller for a network of dynamical systems to optimize a coupled objective function while respecting state ...
Lygeros, John, Summers, Tyler H.
core +1 more source
Low-Rank Modifications of Riccati Factorizations for Model Predictive Control
, 2017 In Model Predictive Control (MPC) the control input is computed by solving a constrained finite-time optimal control (CFTOC) problem at each sample in the control loop.
Axehill, Daniel, Nielsen, Isak
core +1 more source