Similarities and differences between flow boiling in microchannels and pool boiling [PDF]
This paper was presented at the 2nd Micro and Nano Flows Conference (MNF2009), which was held at Brunel University, West London, UK. The conference was organised by Brunel University and supported by the Institution of Mechanical Engineers, IPEM, the ...
2nd Micro and Nano Flows Conference (MNF2009) +1 more
core +6 more sources
A comparison with the three-zone model for flow boiling heat transfer in small diameter tubes [PDF]
Flow boiling heat transfer experimental results, obtained in two stainless steel tubes of internal diameter 4.26 mm and 2.01 mm using R134a as the working fluid, indicate that the local heat transfer coefficient increases with heat flux and is ...
Karayiannis, TG +2 more
core +4 more sources
Two-phase flow boiling in small to micro-diameter tubes [PDF]
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.This thesis is dedicated to the experimental and theoretical study of flow boiling in small to micro diameter tubes using R 134a.
Shiferaw, Dereje
core +7 more sources
Modelling pressure fluctuations during flow boiling in microchannels with inlet compressibility and resistance [PDF]
Confined bubble growth during flow boiling at low pressures in microchannels generates pressure fluctuations that may cause transient flow reversals that disturb the flow distribution in heat sinks formed of parallel channels joined by plena.
Gedupudi, S +2 more
core +4 more sources
Parameter Study of Boiling Model for CFD Simulation of Multiphase-Thermal Flow in a Pipe
The demand for eco-friendly energy is expected to increase due to the recently strengthened environmental regulations. In particular, the flow inside the pipe used in a cargo handling system (CHS) or fuel gas supply system (FGSS) of hydrogen transport ...
Soh-Myung Chung +4 more
doaj +1 more source
A general method for calculation of flow boiling and flow condensation heat transfer coefficients in minichannels [PDF]
This paper was presented at the 2nd Micro and Nano Flows Conference (MNF2009), which was held at Brunel University, West London, UK. The conference was organised by Brunel University and supported by the Institution of Mechanical Engineers, IPEM, the ...
2nd Micro and Nano Flows Conference (MNF2009) +3 more
core +6 more sources
Distributed Optical Measurement System for Plate Fin Heat Exchanger
The acquirement of the flow information in plate-fin heat exchanger (PFHE) is limited by its metal structure and complex flow condition. This work develops a new distributed optical measurement system to obtain flow information and boiling intensity. The
Huajun Li +3 more
doaj +1 more source
Characteristics of onset of boiling under downward flow condition
Understanding of the onset of boiling plays an important role in the design of boiling equipment. Therefore, many studies have been reported so far, but most of these concerned with the upward flow condition.
Takatoshi KAMEDA +2 more
doaj +1 more source
Modelling of non-stationary pressure fluctuations during boiling in a minichannel [PDF]
Boiling in a minichannel occurring at a low mass flow rate is accompanied by non-stationary twophase flow. The analysis of pressure fluctuations during non-stationary boiling in minichannel shows that quasi-periodic changes in flow patterns can be ...
Mosdorf Romuald +2 more
doaj +1 more source
Evaporators used in organic Rankine cycles (ORC) are designed using existing flow boiling correlations that are mainly based on HVAC&R data. However, the ORC evaporators employed in the industry typically have larger diameters and operational conditions ...
Alihan Kaya +2 more
doaj +1 more source

