Results 21 to 30 of about 325,146 (351)
Experimental investigation of non-uniform heating effect on flow boiling instabilities in a microchannel-based heat sink [PDF]
Copyright @ 2011 ElsevierTwo-phase flow boiling in microchannels is one of the most promising cooling technologies for coping with high heat fluxes produced by the next generation of central processor units (CPUs).
A.J. Walton +17 more
core +1 more source
This study tries to employ the computational fluid dynamics (CFD) approach to investigate the influence of the simultaneous use of the metal foam (porous media) and the water-based nanofluid on the boiling flow regime. For this purpose, boiling flow heat
S. Sivasankaran, Fouad O.M. Mallawi
doaj +1 more source
Experimental investigations on the influences of different contaminants to deionized water have been conducted under the sub-cooled flow boiling heat transfer inside the vertical annulus.
Mohammad Mohsen Sarafraz +1 more
doaj +1 more source
Evaporators used in organic Rankine cycles (ORC) are designed using existing flow boiling correlations that are mainly based on HVAC&R data. However, the ORC evaporators employed in the industry typically have larger diameters and operational conditions ...
Alihan Kaya +2 more
doaj +1 more source
Experimental Study of Subcooled Flow Boiling on Heterogeneous Wetting Surface
With the recent increase in power density and miniaturization of various equipment, the requirements for compactness and efficiency of heat exchangers become increasingly stringent. Micro-structured surfaces have a significant impact on flow patterns and
Sun Jia, Lin Yuhao, Li Wei
doaj
The objective of this experiment is to investigate the unsteady heat transfer of R-407C subcooled flow boiling (SCFB) due to the oscillating refrigerant flow rate within a narrow tube oriented horizontally for application in energy efficiency air ...
Wen-Ken Li +4 more
doaj +1 more source
Surface effects in flow boiling of R134a in microtubes [PDF]
This is the post-print version of the Article. The official published version can be accessed from the link below - Copyright @ 2011 ElsevierThe inner surfaces of microtubes may be influenced strongly by the process of making them due to manufacturing ...
Agostini +30 more
core +1 more source
Boiling Synchronization in Two Parallel Minichannels—Image Analysis
In this paper, the boiling synchronization of two-phase flow patterns in two parallel minichannels of 1 mm in diameter with connected compressible volumes was analyzed. The analysis was performed using images recorded with a high-speed camera. The degree
Gabriela Rafałko +3 more
doaj +1 more source
Parameter Study of Boiling Model for CFD Simulation of Multiphase-Thermal Flow in a Pipe
The demand for eco-friendly energy is expected to increase due to the recently strengthened environmental regulations. In particular, the flow inside the pipe used in a cargo handling system (CHS) or fuel gas supply system (FGSS) of hydrogen transport ...
Soh-Myung Chung +4 more
doaj +1 more source
Characteristics of onset of boiling under downward flow condition
Understanding of the onset of boiling plays an important role in the design of boiling equipment. Therefore, many studies have been reported so far, but most of these concerned with the upward flow condition.
Takatoshi KAMEDA +2 more
doaj +1 more source

