Results 111 to 120 of about 884,701 (313)

Molecular dynamics simulation of plane poiseuille flow in nanochannels [PDF]

open access: yes, 2009
This paper was presented at the 2nd Micro and Nano Flows Conference (MNF2009), which was held at Brunel University, West London, UK. The conference was organised by Brunel University and supported by the Institution of Mechanical Engineers, IPEM, the ...
2nd Micro and Nano Flows Conference (MNF2009)   +4 more
core  

TOWARDS THE DESIGN OF LOW NOISE LEVEL WIND TURBINES

open access: yesTASK Quarterly, 2009
According to the authors’ hypothesis generation of high intensity noise is caused by generation of vorticity structures inducing velocities that can be locally higher than the velocity of sound.
PATRYK CHAJA , TADEUSZ KORONOWICZ
doaj  

Influence of the Spray Scrubber Geometry on the Efficiency of Dust Removal – Theoretical Predictions and CFD Analysis

open access: yesJournal of Applied Fluid Mechanics, 2020
The article presents a method of purification of synthesis gas (syngas) produced as a result of biomass gasification with the use of a spray scrubber. The authors focus on the presentation of how individual elements of the geometry of a spray scrubber ...
A. Tomaszewski   +3 more
doaj  

The skills required for transition to university and study in biological sciences: A student perspective

open access: yesFEBS Open Bio, EarlyView.
Bioscience students were asked for their opinions on the value and teaching of skills. 204 responded that teamwork, time management and study skills are necessary to reach University, that scientific writing, research, laboratory and presentation skills are taught effectively during their studies, while other skills are gained inherently through study ...
Janella Borrell, Susan Crennell
wiley   +1 more source

INFLUENCE OF MEMBRANE AMPLITUDE AND FORCING FREQUENCY ON SYNTHETIC JET VELOCITY

open access: yesTASK Quarterly, 2015
This paper presents the results of numerical investigations of a synthetic jet actuator for an active flow control system. The Moving Deforming-Mesh method as a boundary condition is used to capture the real physical phenomenon.
MARCIN KUROWSKI, PIOTR DOERFFER
doaj   +1 more source

Mass spectrometry based identification of AMP‐O‐Tris generated by Thermococcus onnurineus Cas10

open access: yesFEBS Open Bio, EarlyView.
Isolated Thermococcus onnurineus Cas10 generates the noncanonical ATP‐derived product AMP‐O‐Tris while in Tris‐containing buffer as identified via mass spectrometry, revealing relaxed nucleophile selectivity under isolated conditions. These findings suggest that multiprotein Csm complex assembly restricts Cas10 reactivity toward canonical cyclic ...
Su‐Jin Lee   +6 more
wiley   +1 more source

Effect of temperature on the MHD stagnation-point flow past an isothermal plate for a Boussinesquian Newtonian and micropolar fluid [PDF]

open access: yes, 2018
Purpose: This paper aims to analyze the steady two-dimensional stagnation-point flow of an electrically conducting Newtonian or micropolar fluid when the obstacle is uniformly heated.
Giantesio, Giulia   +3 more
core   +1 more source

Why human connection is the true metric of research success

open access: yesFEBS Open Bio, EarlyView.
Human‐centred mentorship can be shaped by mentor attributes, actions, intrinsic drive and career ambition. Drawing on reflections across Singapore and France, as well as workshop insights from FEBS‐IUBMB ENABLE 2024, this article shows that human‐centred mentorship creates the conditions for sustainable growth, well‐being and retention in research ...
Timothy Lin Yun Tan   +3 more
wiley   +1 more source

Investigations of smoothed particle hydrodynamics method for fluid-rigid body interactions [PDF]

open access: yes, 2013
The aim of this project is to investigate the capability of smoothed particle hydrodynamics (SPH) method for fluid-rigid body interactions. SPH is one of the most widely used meshless methods which use particles to represent the system.
Sun, Fanfan
core  

Experimental investigation of PCM thermal energy storage charge and discharge process with aperiodic (ramp) temperature inputs

open access: yesE3S Web of Conferences, 2018
In recent years, the use of storages filled with phase-change material (PCM) is increasingly considered. Such design is characterized by a higher density of thermal energy accumulation in comparison with water storages.
Karwacki Jarosław, Kwidziński Roman
doaj   +1 more source

Home - About - Disclaimer - Privacy