Results 61 to 70 of about 7,293,413 (288)
Arthritis Care &Research, EarlyView.Objective The aim of this study was to test the hypothesis that multijoint osteoarthritis would modify the relation between time and frailty progression, in which more affected joints would lead to larger declines over six years compared to those without osteoarthritis using data from the Canadian Longitudinal Study on Aging.
Carson Halliwell +2 more
wiley +1 more source
Four-Wave Mixing Conversion in QD SOA: reservoir effects
مجلة علوم ذي قار, 2019 In this paper, it is present a model to simulate Four-wave mixing in quantum dot semiconductor optical amplifier, taking into account the influence of carrier heating at reservoir.
Ahmed H. Flayyih, Riyam H. Ali
doaj +4 more sources
Dissecting X-Ray Raman Resonances Using Four-Wave Mixing
EPJ Web of Conferences, 2013 The stimulated x-ray Raman signal has been calculated for the amino acid cysteine using broadband (FWHM ≃14.2eV, 128 as) pulses tuned to the nitrogen K-edge.
Govind Niranjan +4 more
doaj +1 more source
Applied Sciences, 2020 We demonstrated a straightforward approach to generate red and near-infrared laser emissions by a Raman-assisted four wave mixing (FWM) process in a nonlinear Yb-doped fiber amplifier, delivering 342 fs pulses of 241 nJ at 864 nm, 834 fs pulses of 21 nJ ...
Hui Xu +9 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Reproduction of stacking fault energy calculations from literature with a semi‐automated large language model‐assisted extraction procedure: extraction of simulation protocol, atomistic structures, computational parameters, and reported results, ontology alignment, knowledge graph construction and, finally, recomputation forvalidation.
Sepideh Baghaee Ravari +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Tailorable dispersion in a four-wave mixing laser
Optics Letters, 2017 We present experimental results demonstrating controllable dispersion in a ring laser by monitoring the lasing-frequency response to cavity-length variations. Pumping on an N-type level configuration in ${}^{87}$Rb, we tailor the intra-cavity dispersion slope by varying experimental parameters such as pump-laser frequency, atomic density, and pump ...
Kutzke, Demetrious T. +5 more
openaire +3 more sources
Advanced Engineering Materials, EarlyView.The OntOMat ontology establishes a structured framework for polymer matrix fiber reinforced composite materials, integrating manufacturing processes, characterization methods, and multiscale design through the VDI/VDE 3682 formalized process description standard.
Nicolas Christ +19 more
wiley +1 more source
Reconfigurable Photonic Microwave Filter Based on Four-Wave Mixing
IEEE Photonics Journal, 2012 A simple technique to reshape the response of tapped delay line photonic microwave filters is demonstrated. The technique is based on the generation and control of a set of optical carriers by means of four-wave mixing.
Borja Vidal +2 more
doaj +1 more source
Adaptive Foam 3D Printing of Ultralight and Multifunctional Materials
Advanced Engineering Materials, EarlyView.Adaptive foam 3D printing, enabled by expandable microspheres, imparts cellular structures to thermoplastic and thermosetting polymers, manufactured through a variety of processes including fused filament fabrication, direct ink writing, digital light processing, and inkjet printing.
Nariman Rajabifar, Amir Ameli
wiley +1 more source