Results 101 to 110 of about 7,293,413 (288)
Widely Tunable Fiber Optical Parametric Oscillators With Idler Removal Filter
The properties of the singly resonant and double-pass pump fiber optical parametric oscillators (FOPO) are experimentally investigated. An idler removal filter is utilized to eliminate the idler component in a Fabry–Pérot cavity to minimize
Kwok Shien Yeo +3 more
doaj +1 more source
In Situ Magnetic Ordering and Microfabrication of Liquid Crystal Networks with Discretized Alignment
Miniaturizing liquid crystal network actuators typically demands costly laser writing or digital light processing. A low‐cost photolithography platform couples rotating photomasks with a Halbach magnetic array to discretize in‐plane molecular alignment down to 50 µm, producing programmable, light‐responsive grippers, checkerboards, and origami‐inspired
Matthew Gene Scarfo +3 more
wiley +1 more source
Filter-driven four wave mixing laser with a controllable repetition rate
We demonstrate a robust control over the repetition rate of a micro-comb laser by using the Filter-Driven Four Wave Mixing scheme. Results show that the coherence can be kept during the whole process. © OSA 2017.
Sai T. Chu +20 more
core +1 more source
We report on the delay of optical pulses using electromagnetically induced transparency (EIT) in an ensemble of cold atoms with an optical depth exceeding 500.
J Geng +9 more
doaj +1 more source
Rapid thermal annealing reconstructs the BCFO/Nb:STO interface into an atomically thin reconstructed interfacial layer, which reshapes the tunneling barrier and converts a high‐TER ferroelectric tunnel junction into an intrinsically nonlinear, self‐rectifying device.
Hojin Lee +21 more
wiley +1 more source
Wavelength conversion based on four-wave mixing in a highly nonlinear fiber in ring configuration
An efficient system for generating the four-wave mixing (FWM) effect in a short length of a highly nonlinear fiber (HNLF) is demonstrated using a ring configuration, which to our knowledge is the first of its kind to be reported.
M.Z. Zulkifli +11 more
core +1 more source
We present the first experimental observations of phononic four-wave mixing (FWM) in a piezoelectrically actuated free-free beam microstructure. The FWM response is facilitated by the intrinsic coupling between a driven mode and an auto-parametrically excited sub-harmonic mode.
Ganesan, Adarsh +2 more
openaire +2 more sources
A study is presented of four-wave mixing (FWM) in L- and C-band EDFAs. From experiments, it has been observed that FWM scales with the length of Er-doped fibre. It is shown theoretically that FWM crosstalk from EDFAs considerably exceeds that from NZDSF fibre in DWDM L-band systems and leads to a penalty of up to 1 dB in terms of the Q parameter.
Y. Liu +7 more
openaire +1 more source
Amphoteric Cu‐Doping Leading to High Thermoelectric Performance in p‐Type Bismuth Antimony Telluride
This study shows that Cu plays two opposite roles in p‐type Bi0.5Sb1.5Te3 depending on the processing route. Under thermodynamic‐equilibrium bulk‐synthesis, Cu mainly occupies cation sites, increases hole concentration, preserves mobility, and slightly reduces lattice heat transport. The best‐performing composition among the investigated series reaches
Moritz Thiem +15 more
wiley +1 more source
Brillouin-enhanced four-wave mixing with optical chiral states
Brillouin-enhanced four-wave mixing (BE-FWM)—also known as Brillouin dynamic gratings—is an important nonlinear effect in photonics that couples four light waves by traveling acoustic waves. The effect has received much attention in the past few decades,
Xinglin Zeng, Birgit Stiller
doaj +1 more source

