Results 41 to 50 of about 2,591,280 (352)

Experimental study on the effect of post-injection parameters on performance of extra-high pressure common-rail diesel engine

Energy Reports, 2022
The diesel engine combustion process is mainly controlled by the fuel injection characteristics, which will have a direct impact on the performance of the diesel engine, more flexible injection strategy is the development direction of high pressure ...
Lei Zhou, Kun Yang, Zhang Ping, Tao Nie, Xiong Biao, Lin Huang   +5 more
doaj   +1 more source

Enhancing CoFe Catalysts with V2CTX MXene‐Derived Materials for Anion Exchange Membrane Electrolyzers

Advanced Functional Materials, EarlyView.
MXene dervied CoFe composites show increased initial Oxygen Evolution Reaction (OER) activity compared to the pure CoFe and MXene in an Anion Exchange Membrane device. Vanadium vacancies in the MXene plays a role in increased OER activity and hinders Fe leaching in the AEM device over using the pure V2C MXene as a support material for the CoFe ...
Can Kaplan, Karuppasamy Dharmaraj, Thorsten Schultz, Leiqiang Qin, Ningjun Chen, Danielle A. Douglas‐Henry, Bastian Schmiedecke, Merve Buldu‐Akturk, Axel Zuber, Iris Dorbandt, Maximilian Reinhardt, Yael Rodriguez‐Ayllon, Yan Lu, Valeria Nicolosi, Norbert Koch, Johanna Rosen, Michelle P. Browne   +16 more
wiley   +1 more source

Fuel injection performance and spray characteristic of high‐pressure common rail systems at low temperatures

Energy Science & Engineering
The fuel injection performance and spray characteristics of the high‐pressure common rail (HPCR) system at low temperatures are investigated with experiment.
Fukang Ma, Ruifan Xu, Xiaoyu Liu
doaj   +1 more source

Enhancing Direct Solar Water Splitting via ALD of Multifunctional TiO2/Pt Nanoparticle Coatings With Engineered Interfaces to GaAs/GaInP Tandem Cells

Advanced Functional Materials, EarlyView.
Multifunctional atomic layer deposited coatings and interface treatments enhance direct solar water splitting on GaAs/GaInP tandem cells. Optimized TiO2/Pt nanoparticle bilayers ensure durability and catalytic efficiency with minimal optical losses, while H2 plasma pretreatments maximize photovoltage and interfacial charge extraction.
Tim F. Rieth, Verena Streibel, Oliver Bienek, Sergej Levashov, Johannes Dittloff, Kristof Möller, Johanna Eichhorn, Matthias M. May, Ian D. Sharp   +8 more
wiley   +1 more source

Composition and Resulting Band Alignment at the TiO2/InP Heterointerface: A Fundamental Study Combining Photoemission Spectroscopy and Theory

Advanced Functional Materials, EarlyView.
The chemical composition and band alignment are systematically investigated at the TiO2/InP heterointerface. Thin TiO2 films are deposited by ALD on atomically ordered, P‐terminated p‐InP(100). By combining UPS, XPS, and ab initio molecular dynamics, the atomistic structure and electronic alignment are revealed.
Mohammad Amin Zare Pour, Muhammad Nawaz Qaisrani, Christian Höhn, Johannes Laurenz Wolf, Negin Mogharehabed, Jennifer Velazquez Rojas, Wolfram Jaegermann, Erich Runge, Roel van de Krol, Thomas Hannappel, Christian Dreßler, Agnieszka Paszuk   +11 more
wiley   +1 more source

Photocatalytic Versus Stoichiometric Hydrogen Generation Using Mesoporous Silicon Catalysts: The Complex Role of Sacrificial Reagents

Advanced Functional Materials, EarlyView.
This study highlights the importance of accounting for stoichiometric hydrogen produced when utilizing Si photocatalysts. The stoichiometric contribution is sacrificial reagent dependent and decreases with increasing sterics around the catalyst surface.
Sarrah H. Putwa, Sarah A. Martell, Berthold Reis, Simona Schwarz, Mita Dasog   +4 more
wiley   +1 more source

High‐Concentration Mesogen‐Assisted Exfoliation of Low‐Dimensional Nanomaterials for Achieving Ultralow‐Temperature Actuations of Liquid Crystal Elastomers

Advanced Functional Materials, EarlyView.
Most matter is nominally frozen in the polar regions or space, and liquid crystal materials are no exception. Consequently, soft actuators, including liquid crystal elastomers (LCEs), are inoperative under such extreme cold in response to stimuli, as their motion relies on mechanical deformation.
Hyeonseong Kim, Yeon Gyeong Ha, Dong‐Gue Kang, Chinedum O. Osuji, Dae Seok Kim, Changyeon Lee   +5 more
wiley   +1 more source

A Study of Spill Control Characteristics of JP-8 and Conventional Diesel Fuel with a Common Rail Direct Injection System

Energies, 2017
Diversification of energy sources is a key task for decreasing environmental impacts and global emission of gases. JP-8, a fuel derived from natural gas, coal, biomass, and waste plastics, is a bright prospect.
Seomoon Yang, Hoonyoung Moon, Changhee Lee   +2 more
doaj   +1 more source

CO2 Reduction on Copper‐Nitrogen‐Doped Carbon Catalysts Tuned by Pulsed Potential Electrolysis: Effect of Pulse Potential

Advanced Functional Materials, EarlyView.
This study demonstrates that pulsed potential electrolysis significantly improves CO2 reduction performance on copper‐nitrogen doped carbon electrodes. The formation of cationic copper sites and metallic clusters as a function of applied intermittent potential leads to notable selectivity changes compared to potentiostatic reduction.
Dorottya Hursán, Janis Timoshenko, Andrea Martini, Hyo Sang Jeon, Eduardo Ortega, Martina Rüscher, Arno Bergmann, Aram Yoon, Uta Hejral, Antonia Herzog, Clara Rettenmaier, Felix T. Haase, Philipp Grosse, Beatriz Roldan Cuenya   +13 more
wiley   +1 more source

Research of characteristics of working cycle of high-speed diesel engine operating on biofuels RME–E and D–RME–E. Part 1. Indicators of fuel injection system and indicative process

Transport, 2013
The article provides the results of an analyses of the characteristics of fuel injection system as well as the processes indicated in diesel engines 1A41 and F2L511, transferred from working with mineral diesel to working with rapeseed methyl ester ...
Sergejus Lebedevas, Galina Lebedeva, Ingrida Gudaitytė   +2 more
doaj   +1 more source