Results 41 to 50 of about 8,831,063 (384)
Controlling Concurrent Change - A Multiview Approach Toward Updatable Vehicle Automation Systems [PDF]
, 2019 The development of SAE Level 3+ vehicles [{SAE}, 2014] poses new challenges not only for the functional development, but also for design and development processes. Such systems consist of a growing number of interconnected functional, as well as hardware
+3 more
core +1 more source
Energies, 2021 Modern explosion protection equipment, protected by traditional explosion protection technology (as defined by the international electrotechnical commission (IEC) publication IEC60079-ff series standards) and electrical/electronic/programmable electronic
Shiguang Li, Xiaojie Wu
doaj +1 more source
Impact of elosulfase alfa in patients with morquio A syndrome who have limited ambulation: An open-label, phase 2 study. [PDF]
, 2017 Efficacy and safety of elosulfase alfa enzyme replacement therapy (ERT) were assessed in an open-label, phase 2, multi-national study in Morquio A patients aged ≥5 years unable to walk ≥30 meters in the 6-min walk test.
Berger, Kenneth I +11 more
core +1 more source
On the Application of ISO 26262 in Control Design for Automated Vehicles
, 2018 Research on automated vehicles has experienced an explosive growth over the past decade. A main obstacle to their practical realization, however, is a convincing safety concept.
Schildbach, Georg
core +1 more source
Fault-Tolerance by Graceful Degradation for Car Platoons [PDF]
, 2019 The key advantage of autonomous car platoons are their short inter-vehicle distances that increase traffic flow and reduce fuel consumption. However, this is challenging for operational and functional safety.
+3 more
core +1 more source
Vision-Based Safety-Related Sensors in Low Visibility by Fog
Sensors, 2020 Mobile service robots are expanding their use to outdoor areas affected by various weather conditions, but the outdoor environment directly affects the functional safety of robots implemented by vision-based safety-related sensors (SRSs). Therefore, this
Bong Keun Kim, Yasushi Sumi
doaj +1 more source
Safety Integrity Evaluation of Safety Function [PDF]
2018 International Conference on Applied Electronics (AE), 2018 For a possibility of using the safety relevant system in practice, it is necessary to prove, that safety requirements, which are defined based on results of risk analysis, are fulfilled. Part of proving the safety of safety relevant system is also quantitative evaluation of safety integrity of the hardware which is involved in the safety functions ...
Peter Zdansky +2 more
openaire +1 more source
Development and Validation of Functional Model of a Cruise Control System
, 2016 Modern automobiles can be considered as a collection of many subsystems working with each other to realize safe transportation of the occupants. Innovative technologies that make transportation easier are increasingly incorporated into the automobile in ...
Beijer, Jos +4 more
core +1 more source
Affordances and Safe Design of Assistance Wearable Virtual Environment of Gesture [PDF]
, 2015 Safety and reliability are the main issues for designing assistance wearable virtual environment of technical gesture in aerospace, or health application domains.
Fass, Didier
core +5 more sources
Safety Architecture Proposal for Low-Latency Sensor/Actuator Networks using IO-Link Wireless
IEEE Access, 2022 In the field of production automation, IO-Link Wireless (IOLW) offers energy-efficient and cost-effective solutions for networking wireless sensors and actuators close to the machines on the industrial shop-floor. In this paper, a concept is presented to
Thomas R. Doebbert +2 more
doaj +1 more source