A new direct technique for visualizing and measuring gas–liquid mass transfer around bubbles moving in a straight millimetric square channel [PDF]
, 2013 The present paper focuses on the local characterization of gas–liquid mass transfer in a straight millimetric square channel, as constituting the preliminary step required for performing gas–liquid reactions in such devices.
Hébrard, G. +10 more
core +1 more source
Effect of hydrodynamics on mass transfer in a gas-liquid oscillatory baffled column [PDF]
, 2004 In this paper, we present an experimental study on mass transfer of oxygen into water in an oscillatory baffled column (OBC). The objective of this work is to establish the contribution of individual parameters, such as the size of bubbles and the gas ...
Ni, X. +2 more
core +4 more sources
Hydrodynamic and mass transfer in inertial gas–liquid flow regimes through straight and meandering millimetric square channels [PDF]
, 2011 Heat-exchanger reactors are an important part of process intensification technology. For plate geometries, one solution for intensifying transfer and increasing residence times is to construct two-dimensional meandering channels.
Michel Cabassud +7 more
core +1 more source
Direct numerical simulations of mass transfer in square microchannels for liquid-liquid slug flow [PDF]
, 2008 Microreactors for the development of liquid-liquid processes are promising technologies since they are supposed to offer an enhancement of mass transfer compared to conventional devices due to the increase of the surface/volume ratio.
Di Miceli Raimondi, Nathalie +3 more
core +1 more source
Studies on Gas Hold-Up , Mass Transfer Coefficient,Mixing Time And Circulation Time In Bubble ColumnsWith Draught Tube For Pseudo Plastic (Carboxymethyl) Cellulose And Glycerol Solutions [PDF]
Engineering and Technology Journal, 2009 Bubble column reactors are widely used in chemical process industries forcarrying out gas-liquid and gas-liquid-solid reactions such as absorption, biochemicalprocess and coal liquefaction.
Ali Abdul.R.N.Jasim
doaj +1 more source
Effect of partial wetting on liquid/solid mass transfer in trickle bed reactors [PDF]
, 2007 The wetting efficiency of liquid trickle flow over a fixed bed reactor has been measured for a wide range of parameters including operating conditions, bed structure and physico-chemistry of liquid/solid phases.
Baussaron, Loïc +4 more
core +1 more source
Hydrodynamics and mass transfer in bubble column: Influence of liquid phase surface tension [PDF]
, 2007 According to literature, few experiments are performed in organic solvents which are mostly used in commercial gas–liquid reactors. However, it is commonly accepted that data obtained in aqueous solution allow to predict the surface tension effects, and ...
Billet, Anne-Marie +2 more
core +1 more source
Effect of surfactants on liquid side mass transfer coefficients: a new insight [PDF]
, 2009 Specific experiments are proposed to investigate the effect of surfactants on liquid side mass transfer coefficients. They are based on the determination of the liquid side mass transfer coefficient kL at a free gas-liquid interface, under controlled ...
Hebrard, Gilles +2 more
core +1 more source
Inventions, 2023 A mathematical model of the working processes occurring in the gas cap has been developed on the basic fundamental laws of conservation of energy, mass and motion, and the equation of state, both taking into account the change in the mass of the gas due ...
Victor Shcherba, Irina Bulgakova
doaj +1 more source
Investigation on separation performance of vane-type gas-liquid tube separator [PDF]
Chemical Industry and Chemical Engineering Quarterly, 2020 In this work, gas phase distribution characteristic and separation performance of a new vane-type gas-liquid separator were carefully investigated using electrical resistance tomography and numerical simulation.
Niu Jun, Liu Shuo, Xu Jing-Yu
doaj +1 more source