Results 41 to 50 of about 695,323 (266)
Effect of ambient pressure on the performance of a gas-centered swirl coaxial injector
In this study, water and air were used as simulated media to investigate the spray characteristics of a gas-centered swirl coaxial (GCSC) injector under different ambient pressures through experimental, simulation, and theoretical approaches. The results
Yuchao Gao +6 more
doaj +1 more source
Reconciling thermal performance and power-saving performance of counter-flow spray heating towers
Heating tower heat pumps are increasingly used in subtropical areas due to their frost-free characteristics. The spray heating tower (SHT) solves the fouling problem suffered by the packing heating tower and ensures thermal performance. However, the heat
Haijiao Cui +4 more
doaj +1 more source
CO
Results for mass transfer in a rotating spiral device are presented here for absorption of carbon dioxide from nitrogen carrier gas using mixtures of diethanolamine (DEA) and water.
Ahmed A. Ayash +27 more
core +1 more source
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Effervescent atomizers play a crucial role in various industrial applications, where their performance is governed by internal two-phase flow dynamics. Among the different two-phase flow regimes, annular flow is particularly effective in producing fine ...
Z. Alizadeh kaklar, M. R. Ansari
doaj +1 more source
A Novel Isothermal Compression Method for Energy Conservation in Fluid Power Systems
Reducing carbon emissions is an urgent problem around the world while facing the energy and environmental crises. Whatever progress has been made in renewable energy research, efforts made to energy-saving technology is always necessary.
Teng Ren +3 more
doaj +1 more source
H2S–CO2 gas separation with ionic liquids on low ratio of H2S/CO2
Acid gas removal, especially H2S and CO2, is an essential process in natural gas processing. In this research, 1-butyl-3-methylimidazolium bromide [bmim][Br] ionic liquid was analyzed as a hydrophobic solvent with has high selectivity to H2S as an ...
Tri Partono Adhi +6 more
doaj +1 more source
Mass Transfer Modeling of CO2 Absorption into Blended Aqueous MDEA–PZ Solution [PDF]
In this research, the rate of CO2 absorption into methyl diethanolamine–piperazine (MDEA–PZ) solution was investigated. To model the mass transfer flux in the reactive absorption processes, the dimensionless parameters of the process were obtained using ...
Fahimeh Mirzaei, Ahad Ghaemi
doaj +1 more source
This study examines how several molten high‐silicon electrical steels interact with both conventional and recycled MgO–C refractories. For this, various immersion experiments are conducted. In addition to infiltration, a number of mechanisms are identified and explained that control the corrosion of the refractory material.
Lukas Neubert +7 more
wiley +1 more source
This article aims to increase the intensity of mass transfer between gas and liquid in counterflow gas–liquid flow, one of the key problems in designing mass transfer equipment.
Vsevolod Sklabinskyi +6 more
doaj +1 more source

