Results 121 to 130 of about 74,413 (318)
Advanced Engineering Materials, EarlyView.This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Studies on exhaust gas recycling and waste heat recovery for the Z12V190 diesel engine
Kuwait Journal of Science, 2015 The Z12V190 diesel engine has high fuel consumption and low thermal efficiency, and releaseslarge amounts of diesel exhaust gas and waste heat into the atmosphere. This causes hugeresource as well as energy waste.
HOU XUEJUN +3 more
doaj
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
International Journal of Renewable Energy DevelopmentReducing carbon emissions such as carbon dioxide (CO2) and carbon monoxide (CO) from diesel engines struggled with engine performance challenges and fossil fuel limitations. Besides, huge transportation such as ships hardly replaced diesel engines due to
Frengki Mohamad Felayati +5 more
doaj +1 more source
An experimental and numerical investigation of the effect of aero gas turbine test facility aspect ratio on thrust measurement. [PDF]
, 2011 This work describes the outcome of research program investigating thrust measurements in enclosed test facility for modern aero gas turbine engines. Literature work, experimental work and a description of Computational fluid dynamics simulation system
Al-Alshaikh, Abdullatif
core
Advanced Engineering Materials, EarlyView.This work explores the reduction of nickel oxide layers using dielectric barrier discharge plasma in an argon–hydrogen atmosphere. The results reveal a strong temperature dependence, enabling complete reduction of thick oxide layers at 200°C within seconds.
Maria Argirusi +5 more
wiley +1 more source
An evaluation of operation and creep life of stationary gas turbine engine [PDF]
, 2012 During operation, gas turbine components undergo various types of timedependent degradation due to high temperatures and mechanical loading. In the case of stationary GT engines for mechanical power, creep failure mechanism problems are a very common ...
Eshati, Samir
core
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Study on the Effects of EGR and Spark Timing on the Combustion, Performance, and Emissions of a Stoichiometric Natural Gas Engine. [PDF]
ACS Omega, 2020 Lou D, Ren Y, Zhang Y, Sun X.
europepmc +1 more source