Results 241 to 250 of about 17,474 (298)
Modeling of dynamic responses of arresting gear and its sensitivity study based on BP neural network optimized by Whale optimization algorithm. [PDF]
Sci RepDeng Q +5 more
europepmc +1 more source
Identification of noise emmision of a gear unit
, 2007 Belšak, Aleš, Prezelj, Jurij
openaire +1 more source
GEAR UNIT DESIGN AND APPLICATIONS(divisional title)
The Proceedings of the JSME international conference on motion and power transmissions, 2001 openaire +1 more source
GEAR UNIT DESIGN AND APPLICATIONS(Divisional title)
The Proceedings of the JSME international conference on motion and power transmissions, 2009 openaire +1 more source
Investigating Faulty Gear-Unit Vibration
Key Engineering Materials, 2010 A crack in the tooth root is probably the least desirable problem in gear unit operation; it often leads to failure. Signals produced by a gear with a crack in the tooth root, produced through real operating conditions, and signals caused by a faultless gear are used for the analysis.
Aleš Belšak, Jože Flašker
openaire +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Bearings Failure of Gear Drive Unit Caused by Gear Resonance
Mechanisms and Machine Science, 2013Gear transmission units could work properly in the resonance conditions but they cause very unfavorable effects on other components and the environment. It is necessary to identify the resonance range, and afterwards to harmonize design parameters with operating conditions, so as to avoid primary and secondary resonance.
Milosav Ognjanović +2 more
exaly +2 more sources
Volume 4: 9th International Power Transmission and Gearing Conference, Parts A and B, 2003
During the last years it has become more and more common practice in the gear industry to exchange gear data electronically between the different parties. Up to now the format of the gear data is usually DXF, IGES or a company-specific format. A common format, which includes not only geometry data, but also load capacity and other gear-related data ...
B.-R. Hoehn, K. Steingroever, M. Jaros
openaire +1 more source
During the last years it has become more and more common practice in the gear industry to exchange gear data electronically between the different parties. Up to now the format of the gear data is usually DXF, IGES or a company-specific format. A common format, which includes not only geometry data, but also load capacity and other gear-related data ...
B.-R. Hoehn, K. Steingroever, M. Jaros
openaire +1 more source
Solid State Phenomena, 2009
Automatization of gear shift and number selection in passenger cars with stepped transmission result in improvement of driving safety due to concentration of driver’s attention on the conditions of the traffic [1, 3]. Besides, the car can be used by a disabled person.
Jerzy Jantos +2 more
openaire +1 more source
Automatization of gear shift and number selection in passenger cars with stepped transmission result in improvement of driving safety due to concentration of driver’s attention on the conditions of the traffic [1, 3]. Besides, the car can be used by a disabled person.
Jerzy Jantos +2 more
openaire +1 more source
Identification of Noise Emission in a Gear Unit
The Journal of the Acoustical Society of America, 2008Today it is very important to ensure a stable production without unscheduled outages. To achieve this objective it is required to use advanced production technologies, to ensure adequate maintenance of mechanical systems and to monitor the condition of a device or machine.
Ales Belsak, Jurij Prezelj
openaire +1 more source