Entropy‐Driven Design of Low‐Melting‐Point Alloys via Compositionally Complex Strategy
Advanced Engineering Materials, EarlyView.Conventional low‐melting‐point alloys (LMPAs) are limited by a narrow compositional space and inherent property trade‐offs. This review presents an entropy‐driven design strategy that overcomes these limitations, ushering in a new class of low‐melting‐point compositionally complex alloys (LMCCAs).
Yinghui Shang +6 more
wiley +1 more source
The Significant Impact of the Evolution of Porous Architecture in Sol-Gel Processed-Nanoscale ZnO-Bearing Bioactive Glass in a Physiological Environment. [PDF]
Int J NanomedicineMalpani M +3 more
europepmc +1 more source
Fabrication Routes for Ionic Conducting Fiber Strain Sensors
Advanced Engineering Materials, EarlyView.Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw +3 more
wiley +1 more source
A Review of the Structure and Physical Properties of Fluorozirconate and Rare-Earth-Doped ZBLAN Glasses. [PDF]
Materials (Basel)Mpourazanis P, Kielleck C, Eichhorn M.
europepmc +1 more source
Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
Advanced Engineering Materials, EarlyView.The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
Effect of Germanium Substitution for Aluminium on the Properties of Calcium Fluoro-Alumino-Silicate Glass-Ceramics. [PDF]
Materials (Basel)Yu K, Zhang S, Liu Y, Ni W.
europepmc +1 more source
Feasibility and Limitations of the Advanced Replica Process for Bioactive Glasses
Advanced Engineering Materials, EarlyView.Periodic 3D‐printed Kelvin‐cell templates enable a controlled advanced replica process for fabricating highly porous glass lattices. Across P45K9, 45S5, and 13–93, material‐dependent differences in coating, burnout, and shrinkage lead to distinct strut morphologies, while comparable final porosities of 83%–88% are retained.
Swantje Funk +4 more
wiley +1 more source
Influence of Pr<sub>6</sub>O<sub>11</sub> Concentration on the Thermal, Structural, Physical, and Optical Behavior of SNW Glass Systems. [PDF]
LuminescenceAgti FZ, Soltani MT, Santos LF.
europepmc +1 more source