Results 81 to 90 of about 11,008 (256)

Experimental methods in chemical engineering: Temperature‐programmed oxidation—TPO

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract Temperature‐programmed oxidation (TPO) probes the oxidative capacity and redox properties of solid materials—catalysts, metal oxides, perovskites, and carbonaceous deposits. It identifies coke type, distribution, and reactivity. TPO instruments pass an oxidizing gas (diluted O2$$ {\mathrm{O}}_2 $$, air, or less commonly N2O$$ {\mathrm{N}}_2 ...
Gholamreza Roohollahi, Jildimara de Jesus Santana, Alexander R. P. Harrison, Sara Andreoli, Ewa Marek, Stuart Scott, Mohammad Latifi, Gregory S. Patience   +7 more
wiley   +1 more source

Effect of various silica-supported nickel catalyst on the production of bio-hydrocarbons from oleic acid

International Journal of Renewable Energy Development
The conversion of fatty acids into bio-hydrocarbons can be carried out through a deoxygenation (DO) reaction. Catalytic deoxygenation of fatty acids can occur through three reaction pathways: decarbonylation, decarboxylation, and hydrodeoxygenation.
Rafly Riyandi, Nino Rinaldi, Rika Tri Yunarti, Adid Adep Dwiatmoko, Fidelis Stefanus Hubertson Simanjuntak   +4 more
doaj   +1 more source

One hundred years of teaching, research, and innovation in chemical engineering at the Faculty of Chemistry, National Autonomous University of Mexico (UNAM): Birthplace and enduring leadership of the discipline in Mexico

The Canadian Journal of Chemical Engineering, EarlyView.
The teaching of chemical engineering in Mexico started in 1925 at the Faculty of Chemistry (FQ) of the National Autonomous University of Mexico (UNAM). Academic institutions, research centres, chemical companies, technological developments, highly trained personnel, and scientific contributions are part of the legacy from FQ‐UNAM.
Patricia Pérez‐Salinas, Alberto Rosas‐Aburto, Martín G. Hernández‐Luna, Aida Gutiérrez‐Alejandre, Eduardo Vivaldo‐Lima   +4 more
wiley   +1 more source

Selectivity of reaction pathways for green diesel production towards biojet fuel applications. [PDF]

RSC Adv, 2023
Rahmawati Z, Santoso L, McCue A, Azua Jamari NL, Ninglasari SY, Gunawan T, Fansuri H.   +6 more
europepmc   +1 more source

Purification of Li2CO3 Obtained through Pyrometallurgical Treatment of NMC Black Mass from Electric Vehicle Batteries

ChemSusChem, Volume 18, Issue 6, March 15, 2025.
Lithium carbonate (Li2CO3) obtained from the black mass of recycled lithium batteries is dissolved in water under controlled conditions to remove lithium fluoride (LiF), which is present at a concentration of 3.08 % by weight. The dissolution is carried out at temperatures below 10 °C, and it has been demonstrated that lower temperatures result in ...
Laura Rosso, Lorena Alcaraz, Olga Rodríguez‐Largo, Félix A. López   +3 more
wiley   +1 more source

Comprehensive analysis of properties of green diesel enhanced by fatty acid methyl esters. [PDF]

RSC Adv, 2023
Sriprathum S, Maneedaeng A, Klinkaew N, Sukjit E.   +3 more
europepmc   +1 more source

Carbon emission assessment of tunnel infrastructures: From construction to operation

Deep Underground Science and Engineering, EarlyView.
This study develops a lifecycle carbon accounting framework for tunnel infrastructures, covering design, construction, operation, maintenance, and dismantling. Applied to a subsea tunnel case, the framework reveals the carbon emission distribution among four typical tunnel types and highlights potential carbon offset methods for low‐carbon tunnel ...
Luyuan Long, Wout Broere, Xuehui Zhang, Tian Xia, Richard de Nijs   +4 more
wiley   +1 more source

Lattice and Surface Engineering of Transition Metal Oxide Photoanodes for Efficient Photoelectrochemical Water Splitting

EcoEnergy, EarlyView.
This review highlights phase control, facet control, and atomic vacancy engineering as key strategies to enhance charge transport, light harvesting, and surface activity in PEC photoanodes. ABSTRACT Photoelectrochemical (PEC) water splitting is a promising approach for converting solar energy into hydrogen, yet the performance of transition metal oxide
Seonmi Ko, Jehoon Lee, Tae Sung Kim, Taeuk Park, Hyo Jin Park, Junyeob Yeo   +5 more
wiley   +1 more source

Green diesel production

, 2017
73
openaire   +2 more sources

Toward a Paradigm Shift in Low‐Temperature SCR Catalyst Design: Defect Engineering and Data‐Driven Integration

ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
This work systematically reviews the key factors influencing the performance of low‐temperature NH3‐SCR. The mechanism and challenges of defect engineering strategies, such as oxygen vacancies, heteroatom doping, crystal facet exposure, and surface reconstruction, in controlling both activity and selectivity were analyzed.
Rongrong Kan, Pinjing He, Fan Lü, Hua Zhang   +3 more
wiley   +1 more source