Results 71 to 80 of about 3,078,193 (321)
International Journal of Electrical Power & Energy SystemsThe increasing demand for low-carbon resources drives the adoption of distributed energy resources (DERs) to shape sustainable cities. To ensure stable operation and cost-effective inverter deployment, microgrids (MGs) are equipped with grid-forming (GFM)
Muntathir Al Talaq +5 more
doaj +1 more source
Effect of the Resolution and Accuracy of DTM produced with Aerial Photogrammetry and Terrestrial Laser Scanning on Slope- and Catchment-scale Erosion Assessment in a Recently Burnt Forest Area: a Case Study [PDF]
, 2010 Wildfires are a common phenomenon in Portugal, affecting on average 100.000 ha of rural areas per year and up to 400.000 ha in dramatic years like 2003 and 2005.
Cambra, S. +2 more
core +1 more source
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky +5 more
wiley +1 more source
The Use of Aerial Radiometrics for Epidemiological Studies of Leukaemia: a Preliminary Investigation in SW England [PDF]
, 1993 The report presents the results and conclusions of a pilot study designed to evaluate the potential use of aerial gamma ray measurements in epidemiological investigations of leukaemia.
Baxter, M.S. +5 more
core
Smart Fridge / Dumb Grid? Demand Dispatch for the Power Grid of 2020
, 2015 In discussions at the 2015 HICSS meeting, it was argued that loads can provide most of the ancillary services required today and in the future. Through load-level and grid-level control design, high-quality ancillary service for the grid is obtained ...
Bušić, Ana +3 more
core +3 more sources
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Overview of increasing the penetration of renewable energy sources in the distribution grid by developing control strategies and using ancillary services [PDF]
, 2014 Increasing the renewables energy resources in the distribution network is one of the main challenges of the distributed system operator due to instability, power quality and feeder capacity problems. This paper proposes a solution for further penetration
Bozalakov, Dimitar +3 more
core
Operating Power Grids with Few Flow Control Buses
, 2015 Future power grids will offer enhanced controllability due to the increased availability of power flow control units (FACTS). As the installation of control units in the grid is an expensive investment, we are interested in using few controllers to ...
Leibfried, Thomas +7 more
core +1 more source
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source