Results 241 to 250 of about 83,709 (298)

Optimization of Anti-Fouling Piezoelectric Composite Coating for High-Voltage Insulators in Converter Stations. [PDF]

Materials (Basel)
Ouyang Y, Chen M, Pan S, Wang Q, Qian Y, Li Y, Liu Y, Fang P.   +7 more
europepmc   +1 more source

Three‐Dimensional Printed Microarchitected Hierarchically Porous Biodegradable PLA/S/CNT Nanocomposite Electrodes for High‐Performance Lithium–Sulfur Batteries

Advanced Materials Technologies, EarlyView.
Hierarchically microarchitected PLA/S/CNT cathodes are fabricated via scalable fused filament 3D printing as high‐sulfur‐loading hosts for rechargeable lithium–sulfur batteries. The assembled Li–S cells with sulfur loadings up to 17 mg cm−2 deliver an areal capacity of 9.2 mAh cm−2 and retain 96% of their discharge capacity after 100 charge–discharge ...
Vinay Gupta, Pawan Verma, Fahad Alam, Krishnaiahnahundi Manjunathaswamy Mohan, Shanumgam Kumar   +4 more
wiley   +1 more source

New flexible bidirectional converter for electric vehicle substations connecting microgrids. [PDF]

Sci Rep
Vinh NT, Nguyen VT, Van Dung N, Vu HS.
europepmc   +1 more source

Dynamic Behavior Analysis of Complex-Configuration Organic Rankine Cycle Systems Using a Multi-Time-Scale Dynamic Modeling Framework. [PDF]

Entropy (Basel)
Shen J, Li Y.
europepmc   +1 more source

Optimized battery energy management using an improved type-2 fuzzy logic approach. [PDF]

Sci Rep
Naoui M, Romdhane M, Gacem A, Sbita L, Alturki M, Almalaq Y, Albaker A, Alshammari BM, Guesmi T.   +8 more
europepmc   +1 more source

Design of a distributed power system using solar PV and micro turbine-based wind energy system with a flywheel energy storage. [PDF]

Sci Rep
Bhavani T, Rajababu D, Irfan MM, Rakesh T, Sekhar PC, Flah A, Kraiem H.   +6 more
europepmc   +1 more source

A novel MPPT approach for photovoltaic system using Pelican optimization and high-gain DC-DC converter. [PDF]

Sci Rep
Akter K, Motakabeer SMA, Zahirul Alam AHM, Yusoff SHB, Pachauri RK, Malik H, Jadoun VK.   +6 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Grid-Following and Grid-Forming Converter Control Comparison Under Fault Conditions

2021 IEEE 12th Energy Conversion Congress & Exposition - Asia (ECCE-Asia), 2021
Traditionally control of grid-connected converters is based on a grid-following structure, where a Phase Locked Loop is responsible for tracking the angle of the AC grid. However, such control structure leads to stability problems for weak and low inertia grids. Then, a grid-forming control structure is presented as a potential solution.
Carlos Collados-Rodriguez, Marc Cheah-Mane, Francisco-Javier Cifuentes-Garcia, Eduardo Prieto-Araujo, Oriol Gomis-Bellmunt   +4 more
openaire   +1 more source