Results 221 to 230 of about 66,627 (256)
Some of the next articles are maybe not open access.
Understanding the Temperature Field in Plunge Cylindrical Grinding for Grinding-Hardening
Key Engineering Materials, 2010This paper investigates the temperature field in plunge cylindrical grinding with the aid of the finite element analysis. The analysis included the effect of the variation of the depth of cut and that of the repeated heating and cooling caused by workpiece rotation.
Thai Nguyen, Liang Chi Zhang
openaire +1 more source
Temperature Field Analysis in Grinding
2019The paper is devoted to solving an important scientific problem of determining the profile grinding temperature based on the choice of a not complex but at the same time adequate solution from the available analytical ones. The initial prerequisite for the paper developing concept is that of a moving heat source. In engineering applications, the moving
Natalia Lishchenko, Vasily Larshin
openaire +1 more source
Automatic Control Technology of Grinding Zone Temperature in Grinding Hardening
Advanced Materials Research, 2011In grinding hardening process, part’s surface (grinding zone) temperature directly affects the quality of surface layer of heat treatment. The high temperature heat pipe is very good device of control heat transfer. In order to make the grinding zone temperature slightly change in grinding process, this paper describes a design of temperature automatic
W. Cheng, Gui Cheng Wang, P. Liang
openaire +1 more source
Analytical Modelling of Temperature in Cylindrical Grinding to Predict Grinding Burns
International Journal of Precision Engineering and Manufacturing, 2019The direct measurement of grinding temperature is always difficult due to coolant cover and very size of work and wheel interaction zone. At the same time, high heat generation in grinding often leads to grinding burns thereby affecting surface integrity; in this context, theoretical evaluation of temperature could facilitate early detection of the ...
Azhar Thanedar +2 more
openaire +1 more source
Investigation of the grinding temperature and energy partition during cylindrical grinding
The International Journal of Advanced Manufacturing Technology, 2018In this study, the distribution of temperature and energy under the process parameter conditions and thermal physical parameters are investigated using a physics-based model via the finite element modeling (FEM) simulation and experimental validation during cylindrical grinding.
Zishan Ding +3 more
openaire +1 more source
Grinding temperature in high speed deep grinding of engineering ceramics
International Journal of Abrasive Technology, 2009The paper presents an investigation of the thermal behaviour of high speed deep grinding (HSDG) for engineering ceramics, yttria partially stabilised zirconium (PSZ) and Al2O3, using the grindable thermocouple technique. Effects of the grinding conditions, including wheel velocity, feed rate and depth of cut, on the temperature were investigated.
Li Guo, Guizhi Xie, Bo Li
openaire +1 more source
The tribology of the grinding process: An investigation of the temperature increase during grinding
Wear, 1979Abstract A grinding wheel can be considered as a carrier of massive grains which act as abrading heat sources. Therefore in the study of the grinding process cutting forces, heat generation and temperature rise must be taken into consideration. This paper presents a new theory based on the tribological aspects of grinding and on Guest's theory.
openaire +1 more source
Grinding With Abrasive Disks: Part 4—Grinding Power and Temperatures
Journal of Engineering for Industry, 1962Variations in power during disk grinding have been explained and equations developed to represent the power in terms of the grinding variables. It has been shown that depth of cut is below the critical magnitude so that ultimate shear strength of the metal is involved for all but the initial 30 to 120 seconds of grinding.
openaire +1 more source